1. Attachments are working again! Check out this thread for more details and to report any other bugs.

2010 Prius Grill Blocking strategy

Discussion in 'Gen 3 Prius Accessories and Modifications' started by ken1784, May 31, 2009.

  1. usbseawolf2000

    usbseawolf2000 HSD PhD

    Joined:
    Sep 22, 2004
    14,487
    2,994
    0
    Location:
    Fort Lee, NJ
    Vehicle:
    2012 Prius Plug-in
    Model:
    Plug-in Base
    I am sure others have mentioned the heat loss.

    Aerodynamic: About a third of the aero drag is due to the air flowing through the engine compartment and creating turbulence (according to SAE paper by Volvo engineer).
     
  2. john1701a

    john1701a Prius Guru

    Joined:
    Jan 6, 2004
    12,747
    5,243
    57
    Location:
    Minnesota
    Vehicle:
    2017 Prius Prime
    Model:
    Prime Advanced
    I blocked 3 slots the other night, mostly since I only had enough foam available for that. It was a good start. But then snow was forecasted! So, I finished by blocking that last slot on the lower-grille. Now, all 4 are blocked. And sure enough, it did indeed snow.

    That meant photos a whole lot sooner than expected...

    [​IMG] . [​IMG]

    [​IMG]

    Total blocking down below and open on top is the approach I'm sticking with this year. It seems like a good plan and looks surprisingly nice. Larger photos are available on my album.
    .
     
    hybridbear likes this.
  3. Tideland Prius

    Tideland Prius Moderator of the North
    Staff Member

    Joined:
    Oct 2, 2004
    44,768
    16,017
    41
    Location:
    Canada
    Vehicle:
    Other Non-Hybrid
    Model:
    N/A
    I'll see. I have the EBH cord neatly tied to the 3rd grille bar (3rd from the top) so I'll have to split the foam into two for the 3rd row.
     
  4. gazz

    gazz Member

    Joined:
    Mar 16, 2007
    216
    3
    0
    Location:
    Coventry, UK
    Vehicle:
    2010 Prius
    Model:
    N/A
    Very interesting
     
  5. DaveinOlyWA

    DaveinOlyWA 3rd Time was Solariffic!!

    Joined:
    Apr 13, 2004
    15,140
    611
    0
    Location:
    South Puget Sound, WA
    Vehicle:
    2013 Nissan LEAF
    Model:
    Persona

    r u not blocking the top grill?

    i see the recommendation for no more than 50% blocking of the top, but i block 100 % of both in temps below 60º and have done so for years. am i realistically looking at problems down the line?
     
  6. Rhino

    Rhino New Member

    Joined:
    Oct 5, 2009
    460
    41
    0
    Location:
    U.S.A.
    Vehicle:
    2010 Prius
    Model:
    III
    I live in the Washington DC area. I suppose I am too far south to benefit from blocked grills. Any advice would be appreciated. What do you think?
     
  7. spiderman

    spiderman wretched

    Joined:
    Jul 5, 2009
    7,543
    1,558
    0
    Location:
    Alaska
    Vehicle:
    2010 Prius
    Model:
    II
    I bet you could benefit. I put the blocking in and noticed an increase of perhaps .3 - .5 mpg increase. Not fully quantified mind you but I was having problems reaching 53 mpg the last couple of weeks and as soon as I put the blocking in, I reached it no problem. I guess it can cut down on the air drag into the engine comparment. From other suggestions here, I would suspect you would only want to block the lower grill though.
    I am hoping in the near future a thirdparty vendor like Lund will create a nice looking grill block I can run all year.
     
  8. Tideland Prius

    Tideland Prius Moderator of the North
    Staff Member

    Joined:
    Oct 2, 2004
    44,768
    16,017
    41
    Location:
    Canada
    Vehicle:
    Other Non-Hybrid
    Model:
    N/A
    Ken said that the inverter radiator is now located behind the top grille so that's why he recommends 50% maximum blocking.
     
  9. DaveinOlyWA

    DaveinOlyWA 3rd Time was Solariffic!!

    Joined:
    Apr 13, 2004
    15,140
    611
    0
    Location:
    South Puget Sound, WA
    Vehicle:
    2013 Nissan LEAF
    Model:
    Persona
    well its clear that the radiator is separated into upper and lower sections im guessing. cant really see all the feeds to it. so the inverter cooling is a completely separate system?

    wow, not being able to monitor that temp is a bummer. well, i took a closer look at the block on top and i am guessing i am only blocking about 90~% or so.
     
  10. Tideland Prius

    Tideland Prius Moderator of the North
    Staff Member

    Joined:
    Oct 2, 2004
    44,768
    16,017
    41
    Location:
    Canada
    Vehicle:
    Other Non-Hybrid
    Model:
    N/A
    Ask Ken??
     
  11. ken1784

    ken1784 SuperMID designer

    Joined:
    Dec 18, 2003
    2,940
    1,359
    67
    Location:
    Yokohama, JAPAN
    Vehicle:
    2010 Prius
    Model:
    N/A
    Yes, it is!
    The inverter coolant path is "cooler is better".
    There is no thermostat, and the electric pump is always ON to keep trying the coolant as cool as possible.
    OTOH, the engine coolant target temperature is 88C(190F).

    Ken@Japan
     
  12. DaveinOlyWA

    DaveinOlyWA 3rd Time was Solariffic!!

    Joined:
    Apr 13, 2004
    15,140
    611
    0
    Location:
    South Puget Sound, WA
    Vehicle:
    2013 Nissan LEAF
    Model:
    Persona
    TYFI, Ken. sorry for Segway, but i have done 100% grill block on SPM. now granted, not air tight, but have seen many Water temps in upper 200's, 206 is common. have done this for years. soo

    does inverter coolant have a maintenance cycle?
    will its effectiveness be reduced if its been "hot" several times?
    should i get it checked for any possible negative long term effects?
     
  13. David Beale

    David Beale Senior Member

    Joined:
    Jul 24, 2006
    5,963
    1,979
    0
    Location:
    Edmonton Alberta
    Vehicle:
    2012 Prius
    Inverter coolant is the same stuff as engine coolant. It doesn't suffer from heating any more than engine coolant. It's the electronics that can suffer. The longer you run them hot the shorter will be their life expectancy. I doubt anyone would notice however. I suspect they will outlast the "other wear parts" 3 to 4 times.
     
  14. el723

    el723 New Member

    Joined:
    Aug 28, 2009
    18
    1
    0
    Location:
    PA
    Vehicle:
    2010 Prius
    Model:
    III
    Is that the 1/2 inch foam in your photos? Thanks.
     
  15. MSantos

    MSantos EcoAccelerometry

    Joined:
    Oct 5, 2006
    576
    249
    1
    Location:
    Canada, Winnipeg
    Vehicle:
    2018 Prius Prime
    Model:
    Technology
    And just in case anyone wants to take it to the next level:

    Winterizing your Hybrid Vehicle blocking tables and other tips are included

    Cheers;

    MSantos
     
    Tony D, F8L, Judas Prius and 3 others like this.
  16. spiderman

    spiderman wretched

    Joined:
    Jul 5, 2009
    7,543
    1,558
    0
    Location:
    Alaska
    Vehicle:
    2010 Prius
    Model:
    II
    Yes as noted on page 2 of this thread.
     
  17. deltron3030

    deltron3030 New Member

    Joined:
    Sep 25, 2009
    437
    64
    0
    Location:
    Lakewood, CA
    Vehicle:
    2010 Prius
    Model:
    II
    Its my understanding that the 2010 Prius needs very little air through the engine (in terms of intake), and that a warmer engine is a more efficient one. That said, is there any YEAR ROUND grill blocking that can be done on a car in southern california? Perhaps just some of the bottom and leaving the top untouched?

    My main goal would be a year round solution that would reduce the drag forces of the air entering the engine area, and to a lesser extent (since i live in sunny LA), provide a means to warm up the engine a little faster than it does now.

    If 100% blockage equates to a down-parka for one's engine, I'm looking for a light cardigan. :)
     
  18. DetPrius

    DetPrius Active Member

    Joined:
    Apr 24, 2009
    545
    92
    0
    Location:
    Southeast Michigan
    Vehicle:
    2010 Prius
    Model:
    III
    My 2010 Prius is my first one and I really appreciate all the information shared on this site. I'm in SE Michigan and don't have a ScanGuage (yet) and am wondering how much grill block I can/should do at what temps, or should I not risk it w/out a SG. Any suggestions? Daytime highs are now in the 40s and 50s but it won't be long and they will be in the 30s.

    Also, if you block your grill and have to go to the dealership (thinking oil changes) do you remove the block before you go? I can see them advising of problems and voided warranties blocking the grill.
     
  19. MSantos

    MSantos EcoAccelerometry

    Joined:
    Oct 5, 2006
    576
    249
    1
    Location:
    Canada, Winnipeg
    Vehicle:
    2018 Prius Prime
    Model:
    Technology
    My dealers never had a problem with the grille blocking (Toyota or Honda). Some have asked but I always pointed them toward the scangauge and the coolant temp reading in it. After a little chat they would realize that I am keenly aware of the safe operating temp ranges and their concerns would vanish soon after.

    Frankly, If I was them and I had a customer coming in with a fully blocked grille and no means to keep it under watch and safe.... I too would be concerned. Its just common sense.

    Cheers;

    MSantos
     
    WilDavis likes this.
  20. Philosophe

    Philosophe 2010 Prius owner

    Joined:
    Jun 2, 2009
    437
    72
    1
    Location:
    Montréal, Québec (Canada)
    Vehicle:
    2010 Prius
    Model:
    N/A
    Should we rely on temperature tables to know how much grille blocking is safe? Could that be risky without a ScanGauge to monitor the temp?

    As I don't have one, I plan to block the bottom and keep the top opened all winter (gets to -20°C here).