Separate names with a comma.
The original is the O|Rowdy grid charger: V2-grid-charger-discharger MOD Here's the step by step instruction for an Insight, but lot of it is...
There is no safety ground in 10-30. Old equipment often used neutral as ground, assuming that neutral is at 0v, but that is not safe under certain...
The reason why you don’t see chargers or adaptors with 10-30 plugs is because the 3rd wire in 10-30 is neutral, not ground. The correct plug to...
There are 2 parts to reconditioning. First is to set all modules to the same state of charge. P0A80 code is thrown when the delta between the...
@PriusII&C Taking the battery out is a LOT of work. The whole point of the grid charger/conditioner is that after you install the harness, it’s...
@PriusII&C Yeah, I wouldn't take such a long trip in any car with a known issue. Getting a hybrid error 10 miles from home just means you hit...
@PriusII&C, my Prius Gen3 was throwing p0a80 code, and I had to drive it for months before I got around to reconditioning and eventually replacing...
@Teez, no company is going to sell you an adapter that lets you plug in a 120V device to a 240V outlet, especially not Lowe's or Home Depot. You'd...
1. The LPC-100-350 supplies a constant current of 350mA, and the voltage will be whatever the battery is. The 286V rating is just the maximum...
A new Nimh pack should last you another 10 years, at which your Prius will be 22 years old, and you’d have got your money’s worth if it’s still...
Apparently, Toyota used the same charger worldwide, so it's compatible with 240V. The US model just has a 120V 5-15 plug on it. So if you made a...
Try Eagle Malco locking pliers. I got mine from Harry Epstein, under $30. Vise Grips may work too, but the Malco has hardened teeth, and...
@valcun18 since you already have the battery out, modules 1 & 2 can be replaced without taking the entire pack apart. This would be the cheapest...
@Teez, Ultimately, you'll need to make your own decision, but if you are looking for very specific recommendations, here's what I would do: 1....
There are reasons why we use a light bulbs instead of resistors in DIY grid chargers/dischargers. It's dirt cheap. Sockets are also cheap, readily...
