Separate names with a comma.
Attachments are working again! Check out this thread for more details and to report any other bugs.
Figured I'd follow up for posterity. I ended up going with Duralast Gold CV Axle 10307N/10308N that I could source locally from AutoZone. Just...
After looking into it some more and realizing I'd have to get left/right inner/outer and figure out how they go together if I went OEM, I'll...
The more I looked around, the more it seemed like I can't get a complete OEM unit like you can with aftermarket. Are there any videos or writeups...
I recently replaced both the CV axles in my '07 due to them making noise when turning, etc. I went with TrakMotive, which I thought would be ok...
Well, I took everything back apart to remove the lower bearing. I followed the advice in steps 5 & 6 in this Moog pdf to fix the boot. Put...
These are aftermarket units that have zerk fittings on the underside which you can maybe see in my lower ball joint pics . I have tried to get the...
Here's the bearing half broken in the knuckle. [ATTACH] [ATTACH] I finally got everything out. [ATTACH] The castle nuts on the lower ball joints...
I'll give that a shot. I'm honestly not even trying to really torque it, just get it tight enough that I can install the cotter pin. Once I can do...
Hey all. I'm still in the midst of this. One of the boots on my Mevotech ball joints popped and I had to wait for a replacement. I thought getting...
I looked for used, bare knuckles on ebay and most seem to be complete. So I'm assuming I'd be in the same situation with removal of the wheel...
I was afraid there wouldn't be great news. I initially started with the sledgehammer route, but after not making much progress, I decided to buy a...
I'm attempting to replace both front wheel bearing assemblies on my '07 Prius. Got the knuckles off. I bought a 12 ton press to get the job done....
