Separate names with a comma.
Attachments are working again! Check out this thread for more details and to report any other bugs.
I did screen captures of the FFD info, but am not sure in which section of the software I can monitor injector pulse.
I've just finished recharging the traction battery and all modules are 7.9-8.0. SOC reads 59.9. aux battery 13.7. It still won't start. Codes...
I've done 8 modules, and they are charging to 8.29, and relaxing back to about 8.1. Is there info or rule of thumb as to what I would use to...
Sounds like what I've got going on. I wonder though if it would be a low volt, or low current issue. You would think the ECM would open the...
Thanks Patric. Some numbers to go by is helpful. I'm doing a re-charge now should I assume to do a discharge on some to even things out once I...
I checked the DTC and it's P3000 data 389. Which says the battery is bad. I find this hard to accept as the battery is 14.8-15.1 on the cels...
I was ahead of you and tried that theory. The code cleared but the display showed no charging Some sort of system is shut down while this car is...
Thanks for the info on changing my package. :p There is no question that the injectors are not firing during the cranking, but cut in when the...
That's what I did. Disconnected at the rail and ran the fuel pump with a hose on the line to a gas can using the software to run the pump. I did...
I just got stranger Well, it just got weirder. While setting up to get info on MAF and injector pulse from Techstream I attempted to...
Re: included work estimate I just had my injectors redone for $20 each at a place called Doctor Injector in Portland Or area. Very competent...
I was barely running and only after I poured some gas in the intake. In the last 24 hours I've replaced the plugs and the injectors. It still...
I've completed a recharge on the HV battery, and can get it cranking again. After the few short runs its had, I now have 100 pounds even on all...
I was using the Techstreem to do compression. I just got in from the shop where I had removed the valve cover anticipating finding a stuck valve....
Oh what joy... Compression 1. 70 2. 110 3. 0 4. 30 On and engine with 33K on it.
