Separate names with a comma.
I was thinking something like that but externally attached to the very end of the air tube. Maybe circular with four extended tabs bent over the...
Can someone tell me the air inlet diameter of the Gen 3. I am making a rodent screen but don't have the car accessible. I'm thinking maybe 3 inches?
Why is there a heat.shield on the upstream sensor? Why isnt it just a bit larger so I can actually get a tool on it? I'm trying to do a.back...
My Gen 2 has developed a howling noise which increases with speed. I recently had an exhaust leak fixed which reduced the noise level but didn't...
If puston boots are in good shape, can the pistons just be pushed back in or should the boots be removed and then the pistons cleaned first?
Interesting. Im wondering whether the rings lose tension over time. Low tension rings would definitely be more vulnerable to gum/buildup. The...
I would assume that if possible, it is best to have some pressure on the caliper as the bleed screw is cracked open. I like the idea of clear...
I recently did a piston soak using the following technique. I think the result is good but of course, I didn't tear the engine down to examine the...
On my 2013, I am doing front pads and rotors. I disconnected the 12v before starting. Now, I'm ready to compress the caliber pistons but wondering...
I don't have a factory service manual but I guarantee I can reseal a gen 3 timing cover gasket without pulling the engine. My guess is pull the...
