Separate names with a comma.
Attachments are working again! Check out this thread for more details and to report any other bugs.
Hey Blake, Yes, the old eBay. Just make sure you test the voltage when they arrive to insure voltage has not dropped during shipping. If it does...
Hey Ed, We need more information. Please post your read out so we can better assess what is going on with your battery. If all blocks are at...
Success! CAVEAT 1. GEN1, '01-'03, you must remove all four bolts on sub frame to allow it to drop enough to remove and install the STATOR. 2....
Well, it's time for me to tackle this task. My MIL thru the CEL P3191 and today the car limped home. OP, by chance do you have the O-ring part...
Yeah I have to admit I did it quickly I will check all the connection this thing me around Actually I can remove and reinstall on 2 hours The...
Hey Thanks for your Post My bad sub code is 123, I have a techstream The thing is I installed a new from dealer bus bar ergo the better DOC It...
So MIL had code P3000 & P3006, DOC over 20% (36%) serviced (cleaned) and replaced Bus Bar ( could have cleaned it but why bother at $114 ) Code...
I stand corrected, I recall replacing the battery and did not have to reset. :D
Oh good :D
You need to reset the Immoblizer. Turn the key to "ON" position ( DO not try to start her or you will need to do the steps again ) Make sure all...
If I may suggest, pull the battery and have it tested at your FLAPS ( friendly local auto parts store )
+2, Change Plugs, Air Filter and Gas Cap Oring, disconnect battery neg side then after all repairs, reconnect ( immobilizer reset ), turn key to...
Update: Well, Block 15, threw a CEL "battery too weak", checked TIS, confirmed plus P3006 of course, the block went down to 11.1 volts and...
Outstanding OP!
