Separate names with a comma.
Attachments are working again! Check out this thread for more details and to report any other bugs.
That sounds like the PIC can't source enough current to meet the capacitance values of the bus. This guy solved it by using more pins (although...
How serendipitous, I've been looking at my old code just in the last few days. As far as I know this is all new information - personally I had a...
Is there anyway to diagnose what part of the system might be causing problems? I've just finished rigging my carputer so it plays nice with the...
Well something like $35USD should net you a serial<->USB adapter if you're in a bind. I've been using one with my laptop to debug my PIC interface.
Marcin's circuit uses the CAN driver chip to send on the IE Bus. The receive is handled by the quad voltage comparator IC (I'm sure others would...
This is my source code for the current (snooping) implementation of my PIC based IE Bus decoder. To hook it up you need to use Marcin's IE-Bus...
This thread is serendipitous - I've just now finished testing my implementation of an IE Bus snooper that runs on a PIC16F628A chip (much more...
Basically has anyone taken the cover off the nav system and had a look at what GPS chipset it uses? Or, even better, experimented with directly...
Has anyone here had a crack at pulling the GPS coordinates from the factory navigation system? Based on everything I've read, I'm fairly sure...
I've presently got my CarPC hooked up by a direct adaptor cable to the JBL amp. I've got a clean signal with no hum or buzz (very quiet with the...
Sounds like what I should do then - how did you tap it to the battery exactly? Is is possible to clamp a second wire to the actual clamps on the...
I'm in the middle of installing a car computer in my Prius (running to a separate touchscreen mounted in the map slot). Currently I have all the...
