Separate names with a comma.
Attachments are working again! Check out this thread for more details and to report any other bugs.
If it continues and I can't figure out the cause, I'm just going to add a toggle switch to whatever wire in the harness is causing the issue
Idk I guess I could check, no warning lights though
Went out to the car this morning and it had the same issue again unplugged the steering control module under the dash and it started up again, not...
I wasn't using a voltmeter, I was using a snap-on battery tester
Changed the newer steering control module back to the old one and started up
0.1 ohms resistance on the 4in negative cable
Checked the connections last night
No, and the MFD would still turn on if it was, all the electronics that start before it says ready run off the 12v
Nope, drove it around, it would start and shut off when I wanted it to. Put it in our shop, came out the next morning and it wouldn't start
It hasn't been to a mechanic in several years, I've been working on it myself
Ya dome lights and headlights work
The voltage between positive and negative was about 12.7 volts And there was a drain of 500ma that goes away by pulling the dome fuse
I was checking the battery for a parasitic drain and accidentally checked the voltage between the negative cable and the negative post and it was...
I replaced the hybrid control ECU that had it immobile for the past year or so. Drove it around for about 30 minutes and realized a tie rod was...
