Separate names with a comma.
Actually it is China that has been investing in and supporting the US economy for this last decade. Why is buying anything from China a problem...
I also received the brochures from Fountainhead Electronics a while ago. Didn't you get them Flaninacupboard? You would expect they were sent to...
True, lopezjm2001 helped me get my pack back in balance. I sent my BMS off for an upgrade but I still use all the original components. Last tank...
Yes I should have mentioned that. But there is a great difference when it comes to EV driving in a Gen2 or a Gen3. I went along in my friend's...
I would have waited a while for some more results anyway but thanks for the warning John! I'll keep using v3.2 without balancing for the time...
Sounds very promissing Stockton. Is it an entirely new BMS or a standard BMS16D with a firmware upgrade? In that case I would like to send my v3.2...
My friend has a 2010 with an Enginer kit and just like you he cannot drive in pure EV for very long. There seems to be a substantial difference in...
Negative means it flows back into the HV battery. Normally the limit is around 20 mph but on a hot summers day it can go up a little higher to...
I also have a high C15. Between C15 and what do I put the 3.2 ohm resistor?
I'll fix the hose first thing tomorrow. When you figured out how extra fans should be place please let me know. I had the car parked in a cool...
Today was a hot day (for our climate) and it turned out this place was the warmest of Europe with 28°C (82 F). To my surprise I was able to drive...
Whom it may interest, a little about the VB code. The first time the MSComm.Input command is used it does not show the ‘>’ command prompt but it...
Sounds logical. Wouldn't the ICE stay off if the car assumes the SOC is still somewhere around 70% and you are still driving at low speed? @...
You should use two wires; CAN_L (low, pin 14), CAN_H (high, pin 6) compared to GND (ground, pin 5). To power your micro, there is 12 Volts on pin...
Found that the ELM327 datasheet contains detailed instructions on how to connect and about the OBD message formats, why didn't I think of that...
