Separate names with a comma.
Title says it all.
If it's a license plate screw! It would have an M6x1.0 thread.
From what I see, a ring or any other v screw or 1/4 inch spade terminal can be used to function the same way as the expense and hard to get...
Not ideal, but a better option would have been the proper sized red butt connector. I would have also coated the wires with gray aluminum wiring...
It depends on how much you want to do in examining under the hood yourself and how capable you are. In doing so, you can save a lot if money....
I would go to Advance, Auto Zone or O'Reilly and rent a ball joint removal and install press tool.
Only, I don't think that the wires are aluminum unless they have a copper outer coating. Small gauge wires need to be of heavier gauge to carry...
Don't know about aluminum wiring. I have soldered a lot of Toyota wiring and found that it is copper and solders just fine.
I would examine the mechanics work first. The wires are of a very small gauge. If he or she used crimped connectors the connector may have high...
No, The thread on the Gen 4 is M8x1.25. The Gen 5 uses a M12x1.25 thread.
Again [MEDIA]
Still, I'll use Toyota WS.
Cover them when the headlights are not in use.
A marketing gimmick.
