h1ph0panonymous's Recent Activity

h1ph0panonymous replied to the thread Splice a new ABS wheel speed sensor connector pig tail to old or instal full pigtail?.

Sounds about right, so asking a mechanic to do it the lazy way is probably out of the question haha but I bought a full plug and play...

h1ph0panonymous liked PriusCamper's post in the thread Splice a new ABS wheel speed sensor connector pig tail to old or instal full pigtail?.

Electrical tape and or crimps or just about any way to connects wires together will be fine, but... If you were a mechanic in a shop...

h1ph0panonymous replied to the thread Splice a new ABS wheel speed sensor connector pig tail to old or instal full pigtail?.

yeah the wheel well cowl has its own dedicated hole for it with a bunch of rubber like weather long material that will have to be ripped...

h1ph0panonymous posted a new thread.

Splice a new ABS wheel speed sensor connector pig tail to old or instal full pigtail?

Is it easier to open the wheel cowl and instal the new pigtail into the ECU bus in the rear wheel well or splice the new pigtail to the...

Forum: Gen 3 Prius Care, Maintenance & Troubleshooting

h1ph0panonymous liked Cardchucker's post in the thread Just replaced the rear wheel bearings AGAIN, have some thoughts.

One of the rear bearings on my 2012 was shot, probably a result of driving offroad while overloaded. The other side was a little iffy as...

h1ph0panonymous liked johnnychimpo's post in the thread P0117 with Normal temp 180 to 195 F.

above EGR and below EGR. it is my understanding the one above is for your dashboard light both the same just not sure which is the bad...

h1ph0panonymous replied to the thread EGR Cooler Cleaning - PICS.

What mileage was this done at?

h1ph0panonymous liked ArmyChief's post in the thread EGR Cooler Cleaning - PICS.

Well, keeping my threads separated between intake manifold and EGR cooler. Here is the EGR cooler after two days soaking in OxyClean &...

h1ph0panonymous replied to the thread Help! ABS code that won't go away!!!.

Try replacing the pigtail even if it reads good, the terminal could be bad itself.

h1ph0panonymous replied to the thread Wrapping stock intake with tinfoil bubble and then heat resistant wrap?.

Didn’t know the thread was about fixing my car, funny.

h1ph0panonymous attached a file to the thread Wrapping stock intake with tinfoil bubble and then heat resistant wrap?.

[ATTACH] Do it, it’s more of a jigsaw puzzle wrap.

h1ph0panonymous liked ASRDogman's post in the thread Wrapping stock intake with tinfoil bubble and then heat resistant wrap?.

Let'ssss.......... wraaaapppp it up!!!! :eek::eek::D:D:D:rolleyes::rolleyes::LOL::LOL::LOL::ROFLMAO::ROFLMAO::ROFLMAO::ROFLMAO::ROFLMAO:

h1ph0panonymous liked frodoz737's post in the thread Wrapping stock intake with tinfoil bubble and then heat resistant wrap?.

You started this thread more than two weeks ago...and you still haven't fixed your car.

h1ph0panonymous replied to the thread Wrapping stock intake with tinfoil bubble and then heat resistant wrap?.

Make a short ram intake? I’m good, don’t need more hot air.

h1ph0panonymous attached a file to the thread Wrapping stock intake with tinfoil bubble and then heat resistant wrap?.

Again, this whole thread feels like an atheism versus theism debate. I’m not asking you to believe me, the truth claims I’m making...