Separate names with a comma.
In inspection mode open both leaders fill all three[ATTACH][ATTACH]
Did you try the add two hose on the two coolant bleeders to the top coolant tank to bleed the air out of the system? You said you have no heat...
if it just the dash light out and you can dive the car with no light. may have bad cap's on the board behind the dash
try removing the - cable...
heat work before replacing pump.
replaced switching pump worked fine about a month then heat stopped working car run fine but p1123 error code...
Turn out door Actuator was Wasn't working on one door but if you manually lock it the alarm Won't go off or in hook Driver side sensor with...
Or the switch under the dash to turn remote off
One of the Lock actuators isn't working there switches inside or the motor froze up
Try Locking the door and see if they all lock Most likely...
I did worked the same. O2 sensor little tight fit. Thought it would be louder but it wasn't
After market $120 on eBay
Add metal washer have to remove the rubber one to get the metal one one has to seat flat on the fuel injectors
You have a air leak at the seals I had to a washer to the top of the fuel injector to push them in. Tried OEM seal and injectors still same but...
Have you touched the fuel injectors?
If you did and the injector are loose add a washer to the top you will have to remove the rubber seal off the injector to get the washer over....
Did you do the Injectors before the noise