Separate names with a comma.
Attachments are working again! Check out this thread for more details and to report any other bugs.
All, It's always good to refresh some of these threads with new information. I experienced an interesting (albeit temporary) failure on my 2007...
Can you tell me where you found this? This disagrees with the current range that is supposed to be acceptable to the ECM which was posted as...
The "easiest" way to do this is to remove the wipers, plastic leaf catcher, then the wiper motor. Then pop out a few of the harness clips on the...
Ok...the fine engineers at Toyota have me stumped with the same problem as Prius4ed. I am getting a P2237 code...and I am into this with three...
Can you share what the final outcome is? I've got the same error...and have tried three different A/F sensors. Let me tell you...that getting to...
I might agree to ‘some’ extent. However, my son’s car...nearly the same month of manufacture...did not experience the same problems. So...he was...
You both assume too much. You overlooked the part in the post where I described going slower and NOT using cruise control to specifically protect...
Stats: 2007 Gen2, 240,000mi on original battery. Ok...the older battery does NOT charge well or hold a charge at altitude. I’m talking straight...
My 2007 is having the same symptom. Started after a long climb on a hill. If the engine RPM started to climb (on the high side, but not...
Eulo, I was just as surprised...the crack was microscopic...but leaked a TON of water. No leak after sealing the crack.
FOUND AND SOLVED MY WATER LEAK See my attached PDF detailing the microscopic body crack (described above)...after applying sealant, the leak is gone.
Just discovered a similar leak in my 2008 Prius. I found a small pool of water on my rear cargo mat...the source of the water was coming out of...
I am having the SAME problem. What was your solution?
usbseawolf2000, Your CSV file column "Header" has numbers in it (e.g. 7.00E+02). What is this used for? Also, can I send commands to turn off...
use "ISO 15765-4 CAN 11bit 500k baud" in the settings for Torque (or any interface to the gen2 Prius).
