Separate names with a comma.
Attachments are working again! Check out this thread for more details and to report any other bugs.
I just replaced a bad module in my 2006 Prius HV battery and then reconditioned the whole pack and am now using the Traction Battery Monitor to...
Thanks for the reply, Jeff. I assume you meant #15 needs to be replaced instead of #13. I didn't have time for additional testing so I ordered a...
Well, the charge/discharge cycles I performed did not fix the problem, for a very good reason. Although I messed up the first up/down cycle, I...
I updated my post before I saw your last reply and indicated I did change to the 2x75W load at 182V. I was planning to go to 134V like the first...
Rut-roh (a Shaggy/Astro term for those old enough to remember)!! It appears I've followed the wrong path after all. My first complete discharge...
I'm a little confused on which table I should use to determine the voltages I need to go down to before switching to the next lower discharge...
You must be referring to the white connector located right near the 12V battery and I assume the reset is performed after reconnecting the 12V...
How does one do a 2-3 minute reset of the 12V system?
Jim, I didn't have time to include a lot of the details in my original post, which I know are important for folks here to provide educated...
You're absolutely correct! When the HA meter said 123V, my meter said 167V. I've got a bad meter. So, if things are linear here, that would put...
Wow, thanks for the quick reply!! I"m not sure what you mean by "stopped discharging w/200W a long time ago". I let it charge for 24 hours and...
Hi there. New HA product user here. I have a 2006 Prius with 125K miles that recently displayed the standard red-triangle, threw the standard...
I know that. If you look at the two different wrench designs, the x-beam design has a wider shank profile when turning than the standard design...
I'm considering buying this X-Beam design 19mm wrench for this job due to it's flat surface area in which to apply more pressure. I'm concerned...
