Separate names with a comma.
Attachments are working again! Check out this thread for more details and to report any other bugs.
Successful bleed! Here's what I did: 1: Without connecting the 12V, I performed a manual brake bleed - got some air/fluid out of the front. 2:...
Tom, I read a thread where you said you purchased an AP200 Scanner. Can that scanner do a full brake bleed?
Also, as mentioned in my other post, I connected the front brake lines and left the top line loose. But when I added fluid, I didn't see anything...
Tom, It's difficult to read your instructions but I think you're saying the following: 1: Connect the 12V. Remove the relays. Turn the car on?...
Yeah, I just can't find good step by step instructions. I'm hoping someone here can outline the procedure and answer some of my questions. If I...
For the life of me, I'm unable to find a video that shows a Prius Gen 2 brake bleed with Techstream. Furthermore, when I search this forum for...
New (well used) unit is in! I found it more difficult to get the replacement in compared with removing the old unit - most people seem to have the...
You were actually one of the sources that seemed to indicate Thinkdiag was confusing, "ThinkDiag works but their language translation makes it...
Hmm, when I was doing my research, I recall the Thinkdiag Mini as just being a basic code-reading scannner, not capable of bidirectional control....
No issues fitting it in my Gen 2.
That was difficult but I managed to get the actuator removed. I did break one of the plastic clips (see attached pic pink square) holding the...
Well tonight's the night - I'm going to start taking things apart - my plan is to at least get the inverter out of the way. Then I'll have time to...
Yeah, that is consistent with my research. Hopefully, my cable works with the bleeding function. I'm considering picking up a Thinkdiag scanner as...
I just installed Techstream version 12 on a 64 bit Windows 10 laptop using a virtualbox/windows xp. I'm getting ready to replace my brake actuator...
