Separate names with a comma.
Attachments are working again! Check out this thread for more details and to report any other bugs.
Have you tried this: GenIII Prius Custom PIDs for Torque app | PriusChat They work on Prius III and Yaris Hybrid. I assume that they will work on...
Actually I did. It is much harder to force Prius to refuse regen braking but quite easy in Yaris Hybrid (= Prius C). You need some speed, some...
If you are completly sure that the car is completly OFF then visit your service as soon as possible. Hybrid battery is disconnected from the...
New observation from my Prius Gen III, 2011 with recent IGBT firmware patch, European. 1) Car parked for 4 consecutive days 2) Outside...
At 15 kmh braking on a step hill into underground garage I get steady -20 AMP battery power measured by Torque. I'm going to have firmware changed...
My only complain for this glass is it's colour. It would be better if it could be better matched with rest of the windows. Maybe neutral gray?...
Guys... I'm not sure what are you fighting for... I'm yet to write an article about differences between the two (Prius 2011 EU spec VS Yaris...
I think that it should be reprogrammed in a bit more advanced way. 1) Car started normally (fob battery fine) - it should drive without fob inside...
Yaris Hybrid (I assume the same construction as Prius C) uses more battery range. I've pushed it recently to it's limit while recording data on...
They did. As soon as engine is fully warmed (if we can say that in hybrid) it will shut down :-) Mine during winter never reached temperatures...
You are right, except Toyota didn't take grill blocking into account when creating instruments cluster. If it's not why showing temperatures. If...
My own Prius shows IGN = -5 in S1A. Allways. Read by Torque + ELM327 BT.
Hi! I assume that Prius+ and Prius manuals are similar in construction. So there is a section about "Customised settings". It lists some stuff...
The forum (not Priuschat, but the site you tried to link to) is infected. I've gathered returned HTML code by unix curl app. I'm attaching...
Can you record it and put somewhere? I don't hear any annoing sounds from my engine. I can only barely hear inverter noise.
