Separate names with a comma.
Attachments are working again! Check out this thread for more details and to report any other bugs.
My Toyota dealer said he can do it in one hour ($165). I think that after the brakes, everything else will be fine for now. I plan to give 2...
I just tried to bleed the front brakes. I think I got some air bubbles, but the petal still goes too far down. I probably need to start all over...
XHORSE MVCI PRO J2534 Vehicle Diagnostic Prog-ram Cable XDMVJ0 Replace I found this on ebay. They claim "Stable and smooth" . I ordered it,...
This A.M. I got the same results, except after I pumped up the brakes good, a beeper sounded. $169 does not sound bad if I was sure that it would...
Interesting. I have read posts where they needed to try several times before anything came out of the the stroke simulator. I will try tomorrow...
I am running T S ver 12-20-024 which is old. Should I try another version if I can find it and able to set it up? My brake codes are C1203, C1336,...
I did get "lost communications" 2 times. But, does the T S tell the pump to run or does T S only tell me the steps (one way communications) for...
I have a new pump and actuator installed. 2 weeks ago, I bled brakes the old school way. I had no scanner. Now I have T S and when I bleed the...
I sincerely thank all of you for your help. I finally got my free software loaded and working. I watched videos of setting up the software and...
Than you Chapman I am understanding you to say that the invalid mode is used to replace old fluid (flush the system) but is not used to bleed the...
Can you recommend scanner software that will do the ABS bleeding and linear valve offset? Will Torque Pro do that? I have an iphone and an OBD2...
I replaced the booster pump and master cylinder with new parts on my 2010 Prius. I visually compared the clevis adjustment bolt of the new and old...
