Separate names with a comma.
Finally wrapping up my audio upgrade, maybe this info helps you | PriusChat
Amazon product B09DTY8PMD It plugs in between the stereo and the feed TO the speakers. You cut into the FR and FL wires ON THE EXTENSION YOU...
Before I go on I do want to say what I've said before to others... your best bang for the buck upgrade with minimal hassle is replacing your dash...
The OEM JBL upgrade (which AFAIK makes no changes to the power delivery) is rated for 800W (66A on 12v) peak output so that's what your peak...
Never dropped below 14v for me after disconnecting. Stayed between 14-14.1v. No CEL. I'm thinking I'm gonna leave it disconnected as my OEM...
Lol I knew someone was going to bring that up, but no. I have not used that umbrella yet this year. It sits back there waiting for its time. Plus...
Cowling came off pretty easily. Lift seat cushion, lift foot trim door panel, remove 2 plastic push clips, then just pull semi-gently as the...
Door seals checked and tested, all dry. Pulled the small plastic trim panel at the bottom of the door that hides the body wiring, that's all dry....
Trunk area is dry. It's where my amplifiers live. Never noticed any water back there in any capacity and I've been in and out of there in all...
I spoke too soon. During a cleaning I pulled up the rear all weather mats and noticed that under them they had speckles of condensation on the...
"Base model sounds really great but" [IMG]
I hate to bring back chatty a thread which has gone dormant because it's nice when you guys finally stop beating a dead horse, but I did want to...
JL Aduio VX600/6i and NVX VAD10001 v2 Monoblock amp for the subwoofer.This was my initial wiring attempt. Cleaned up since then.
Driver door done with a rough string measurement. I used a 1khz tone and set the passenger door's timing using phase alignment (inverted polarity...
[MEDIA]
