Separate names with a comma.
Attachments are working again! Check out this thread for more details and to report any other bugs.
TIS shows voltage of all blocks hovering in the 15.2V range atm, with about +/- 0.1V. State of Charge on the battery is ~35%, but is slowly...
Thanks for the PDF
I repaired the battery on my Prius 2007, and there are now VSC/traction lights as well as the Master Warning Light, and TIS is showing...
So I pulled the battery out, cracked it open and measured the resting voltages. Then I rigged up a car headlamp to some clips, and measured each...
Ok, I decided to bypass the connector and avoid the hassle of pulling the terminals out and re-soldering onto fresh wire. I went ahead and got...
So I did a bit of looking around about the issue, came across this thread DASH Error Lights Exclamation w/Triangle, VSC, and small Exclamation -...
Received my MiniVCI, set it up on the Prius. Since the 12V battery was unhooked, previous error codes were clear. Attempted to run the Active...
Best way to load test the modules? Car headlight with some wires soldered on, with alligator clips at the end? I was under the impression that...
Pulled the battery apart and re-checked the voltages of all the modules. Here's my data. Values are in volts. Modules with a (*) are ones that I...
Well, starting yesterday I noticed that the ICE was spending more time than normal to charge the HV, even though the HV was at 5-6 bars. I also...
When doing the discharge>charge cycling, the module produced a maximum of ~1100 discharge capacity. After 3 cycles, it was still around ~1100....
Once I get my Mini-VCI in, I will monitor the voltages with it. I don't particularly feel like ripping apart my HV battery again to test the...
Hehe, perhaps. I am going to be placing an order for a Mini-VCI tomorrow morning, hopefully I can get it here this week to diagnose.
Quick update I drove the Prius to the store today. NO Hybrid Warning Light, YES VSC/Brake/Master Triangle. Halfway there, the check engine light...
