Separate names with a comma.
Attachments are working again! Check out this thread for more details and to report any other bugs.
I had remembered seeing that but just put it back in and ordered one ($8) with two new studs and an intake manifold gasket.
Called USAA and that doesn’t apply to North Carolina unfortunately.
Thanks for the reply. I had them change the MAF last week and took out the EGR cooler again last weekend. No more CEL and have the old MAF sensor....
I have full coverage but carry $500 deductible.
Thanks. I was tackling the lower bolt on the side of the engine block above the lower stud and blocked from the side by the cooler. Was using an...
That is correct! Do you know if that gasket can be put in just by removing the two bolts and studs that connect the rear of the cooler to the...
So, I took everything back off today and cleaned the egr cooler real good (and, unfortunately, broke my windshield in the process). Anyway as...
Thanks for both recommendations! Probably look on FB marketplace for both. Because $100 here and $100 there adds up quick when your trying to be...
I’m going to do that. I’m going to have to redo it again because something is just not right. The car is louder now. Kinda sounds similar to an...
Thanks for the reply. Picked it up from the dealer today with the replaced MAF. Don't know where the MAP is though, but will look it up. This...
Thanks for the reply: Update: I picked it up from the dealer this morning with the replace MAF and all seems well so far. So looks like I didn't...
136,000. The engine light came back on this morning so I broke down and took it to the dealer. They told me it was the code for the Mass Airflow...
Just did the egr pipe/cooler job outside in 100 degree heat. Started at 6:30 AM thinking I could get everything torn down to just having to remove...
