Separate names with a comma.
Attachments are working again! Check out this thread for more details and to report any other bugs.
When replacing Gen 3 TPMS sensors, a relearn process is required to input sensor ID into the computer. So either the tire shop installed the...
All depending on shipping, I may have one for sell off a 2012... My brother was in an accident, was hit by an uninsured vehicle and he only have...
I just received mine for a 2005 Prius, so good chance you'll get yours soon. .
Try cleaning EGR circuit and intake manifold.. Helped some friends's interstate fuel economy from 38 to 47 .
If I remember correctly, optimal temperature range should be between 75° ~ 78°, and no higher then 110° lithium ion battery should not higher...
#1. Are you sure the head gasket is leaking coolant? #2. Coolant pump is likely bad, but it's not over $250 when order online from a Toyota...
FYI, RTV gasket maker may take up to 24 hours fully cures. I usually let it set overnight, before I put any fluids in it to prevent possible...
I have one just like yours, and I'm thinking about using a pulling tool to pull it outto inspected Normally, you can just pull it out with your...
I would suggest check for fault codes, using ab OBDII reader or auto parts store usually do it for free.. Possible cause.. Water pump,...
Friend of mine's Prius recently shown code P0A94, and it was the IPM need replaced. Although dealership said the recall was over but fortunately...
Do you have any power to the dash? If not, check orange hybrid battery plug, be sure it's pushed in and slide to lock Posted via the PriusChat...
Here you go.. Zerex Asian Vehicle Red Silicate and Borate Free 50/50 Prediluted Ready-to-Use Antifreeze/Coolant 1 GA https://a.co/d/8KRqDzh...
Yes, I recommended that because OP has already changed coolant multiple times, plus new radiator should not have clogging, ... I believe engine...
I've always check cylinder head movement, make sure they are able to spring back and forth from all directions, and also check if it drain...
Possible... So, far no bent piston rod, everything else loosks okay.. Will check cylinder head when I make it back in town tomorrow morning......
