Separate names with a comma.
Attachments are working again! Check out this thread for more details and to report any other bugs.
As for the handle.. that doesn’t sound right (gen2?) If it looked like a square handle and not a silicone pads that you press... its half broken...
Which year car? Crawl into the back. Pull out the floor, and there is a removable square in the bin, behind the catch mechanism for the door. You...
hello bob, on my 04, i had a similar issue when an ignition coil was starting to go bad.
seemed dark to me. the only way to see through it is with my spotlight. that sample is from me lostening the plug, not fully temoving it.
[ATTACH] [ATTACH] first pic is sunlight. second is a high power flashlight. I pulled a little fluid. It almost smells gasoline ish. A mix...
11.2 or so is roughly enough to start the car. Not recommended but it will work. As soon as ign on it hit, it should have the dc converter to...
I've been thinking transaxle failure since the original botched install. Justtires is owned by Goodyear. They said they would replace it if they...
Gas reads 0. Seems typical since every major error and it tends to read like that. Scangauge also sees 0 though which I find odd (usually it's...
Lights and accessories come on. 12v jump point under hood is same voltage as battery (12.2) When I attempt to start the ️Ready light flashes a...
I have 12v power but no help from the inverter. If I were to have the power button double pressed (ign on) and disconnect the battery, it would...
Mini vci? I'm still not getting any feedback on the 12v side (doesn't jump when ign on is triggered). From what I've figured out, the fusable...
An update: I replaced the inverter, pump, and fluid. I still can't get it to start. My scangauge II doesnt ready any codes. My 12v was dead so I...
if i were to re assemble and try turning it on i would probably get errors, a non start, and no codes. the no code part bugs me. ive only seen...
i figured since i tested it with a different 12v souce two days after and it wouldnt go into ready mode, that it may be that piece. ive found...
ill look up my vin to see if its appliable. i did read a little about it last night. if that recall was active a few years back, i may have had it...
