1. Attachments are working again! Check out this thread for more details and to report any other bugs.

vallesj's Recent Activity

  1. vallesj replied to the thread P2196 - how to tell which O2 sensor? (2010 Prius).

    In my case, I did what was the most logical reason for the code. But I was ready to do the the 15 pages troubleshooting procedure and...

    Aug 24, 2024 at 6:32 PM
  2. vallesj replied to the thread P2196 - how to tell which O2 sensor? (2010 Prius).

    Well, I just replaced the a/f ratio sensor with the one from the exploded original engine and no more dtc, just 15 minutes job with the...

    Aug 24, 2024 at 6:28 PM
  3. vallesj replied to the thread P2196 - how to tell which O2 sensor? (2010 Prius).

    Thanks for sharing! It is just unfortunate that ya had to pay almost current value of the car.

    Aug 24, 2024 at 6:20 PM
  4. vallesj replied to the thread Re-hydrating the battery modules..

    Thats the recommended quantity consensus here, around 9ml which is topping each cell and then remove the excess until the cell is just...

    Aug 23, 2024 at 9:21 AM
  5. vallesj posted a new thread.

    How to refill refrigerant.

    When we replaced an exploded engine on my kids 2011 prius, i asked my son to disconnect the ac compressor from the engine while I worked...

    Forum: Gen 3 Prius Care, Maintenance & Troubleshooting

    Aug 22, 2024 at 4:39 PM
  6. vallesj replied to the thread Generic Freon in 2010 Prius III and Hybrid System error.

    You need to connect to odbd port to check dtc's. Otherwise is like buying a lotto ticket

    Aug 22, 2024 at 4:18 PM
  7. vallesj replied to the thread Re-hydrating the battery modules..

    How adventurous ! Those looks interesting... how much it cost them and where? I googled yabo and I found them on Alibaba.com with a...

    Aug 22, 2024 at 11:40 AM
  8. vallesj liked pasadena_commut's post in the thread Re-hydrating the battery modules..

    Or you could just toss a lit flare into the cabin and achieve the same result a little faster and with less work and expense.

    Aug 22, 2024 at 9:32 AM
  9. vallesj replied to the thread Re-hydrating the battery modules..

    Same as John, did 1 drilled hole the size of the ball air injector needle.. For the charge/discharge procedure, used a hole per cell (6)...

    Aug 22, 2024 at 9:30 AM
  10. vallesj attached a file to the thread Re-hydrating the battery modules..

    Thanks for the reply! I am trying using distilled water and 10% of Potassium Hydroxide, but I am encountering same situation as Alex...

    FLIR_20240820_055113_346.jpg Aug 21, 2024 at 11:35 AM