LED Turn Signal Relay/Flasher

Wonderful...I forgot to ask...after

I install this:

LED Flasher Relay FIX Hyper Flash Turn Signal Light FOR Lexus Toyota 81980 50030 | eBay


I won't need this anymore right?

LED Light Load Resistor Kit - LED Turn Signal Hyper Flash & Warning Fix | Car Bulb Installation Supplies | LED Car Light Bulbs | Super Bright LEDs

 

Correct, no resistors needed after replacing flasher relay.

 

Thanks again Xliderider.

 

I just got my relay today in the mail! That's my project for the weekend... I think I'll start with a few back pain killers right away before bending under the dash! Thanks for sharing your input!

 

I would like to see the video, I cant figure out after the yellow tag wheres it at

 

Thanks for the post. Can anyone still watch the video? It says it's private

 

If I remember correctly, the flasher is directly above the steering column. I'll try to get a photo of mine when I get home.

 

I recall the conclusion being the v 'flasher' is integral to the bezel PC board. There is no separate 8-pin flasher as on the hatchback. I never found one, despite busted knuckles from thrashing around up there.

 

yea... I can't even find the relay.. So the video wold be great... But as u said its private by some reason

 

Finally took thing fking relay off... if anyone needs help, message me...

 

Go for the relay that does the wig wag and euro signal capabilities.

 

On a hatchback, not a v, right?

 

Dont think the V has a Turn signal relay at all, its built into some circuit board in the V.

 

Yes, that was my conclusion 18 months ago (post #28). Just wanted to be sure.

 

Hi All!

I'm a 2015 Prius owner in northern california, anyone here know how to get into the flasher relay for the regular prius? any help would be greatly appreciated

-Juno

 

Thanks for all the guide. It helped tremendously. Too me less than 10 min to take out the old relay and put in the new adjustable.

Here are some pictures. Hope it helps.

Out with the old
In with the new and test
Clip back to position

It helps with my small frame. I was able to lie on the brake pedal and had easy access to the relay.

 

Here is a video of it. Manage to finally make a video.

 

Thanks for all the info! Still I have a question.

With the oem relay if one bulb goes bad there is hyperflash as result warning you to check which light doesn't work.

With this new led-relay is it the same? Or you just need to check from time to time.

 

Just tested and it doesn't hyperflash when I took off one bulb.