1. Attachments are working again! Check out this thread for more details and to report any other bugs.

2008 Prius ABS Control Module Failure - Questions w/ Diagnostic Screenshots

Discussion in 'Gen 2 Prius Care, Maintenance and Troubleshooting' started by Geedis, Jun 17, 2019.

Tags:
Page 2 of 2
  1. Patrick Wong

    Patrick Wong DIY Enthusiast

    Joined:
    Mar 8, 2008
    18,200
    6,479
    0
    Location:
    Green Valley, AZ
    Vehicle:
    2015 Prius
    Model:
    Two
    Hmm, I do not think that any programming is required relative to replacement of the brake actuator. Check eBay regarding establishing a reference cost of a used unit.
     
    #21 Patrick Wong, Jun 19, 2019
  2. ChapmanF

    ChapmanF Senior Member

    Joined:
    Mar 30, 2008
    24,373
    15,865
    0
    Location:
    Indiana, USA
    Vehicle:
    2010 Prius
    Model:
    IV
    Does it have an offset-learning step like the gen 3? Maybe that's what somebody would call programming.
     
    #22 ChapmanF, Jun 19, 2019
  3. BLNT

    BLNT Junior Member

    Joined:
    Jun 12, 2019
    37
    19
    1
    Location:
    Hungary
    Vehicle:
    2005 Prius
    Model:
    Two
    The 'programming' part might relate to bleeding the system that can be done as far as I know with the Toyota Techstream (TS) Diagnostics system. Maybe the mechanic has the system (It can be even bought from Amazon). Overhere in Hungary, this service set me back a few hundred $. This price in the US might be reasonable as I saw a few posts in the Facebook group. It is a big job though.

     
    #23 BLNT, Jun 19, 2019
  4. Tokar

    Tokar New Member

    Joined:
    Jun 18, 2019
    1
    0
    0
    Location:
    Land Of Ta
    Vehicle:
    2012 Prius Plug-in
    Model:
    Plug-in Advanced
    Are you the true Geedis from the Land of Ta?
     
    #24 Tokar, Jun 19, 2019
  5. Patrick Wong

    Patrick Wong DIY Enthusiast

    Joined:
    Mar 8, 2008
    18,200
    6,479
    0
    Location:
    Green Valley, AZ
    Vehicle:
    2015 Prius
    Model:
    Two
    True, it is necessary to initialize the linear solenoid valve and calibration.
     
    #25 Patrick Wong, Jun 20, 2019
(You must log in or sign up to post here.)
Page 2 of 2