1. Attachments are working again! Check out this thread for more details and to report any other bugs.

Avid Ascend, uneven wear - PSI?

Discussion in 'Gen 3 Prius Care, Maintenance & Troubleshooting' started by Kurt Weiske, Nov 12, 2021.

  1. Kurt Weiske

    Kurt Weiske Active Member

    Joined:
    May 6, 2014
    177
    130
    1
    Vehicle:
    2014 Prius
    Model:
    Plug-in Base
    all.

    My Avid Ascends (Not LX or GT) from 2019 are wearing on the inside and outside edges. I rotate them every 10K miles and keep them inflated, usually to 35 PSI.

    The wear pattern seems to indicate underinflation rather than a camber problem.

    They have an 85K mile warranty, I'm looking to have to replace them at 55K. Not unheard of, as mileage warranties are more of a relative comparison than an indicator of how much life you'll get out of them.

    What tire pressure do you run your tires at?
     
  2. bisco

    bisco cookie crumbler

    Joined:
    May 11, 2005
    107,571
    48,862
    0
    Location:
    boston
    Vehicle:
    2012 Prius Plug-in
    Model:
    Plug-in Base
    42/40, but it's not necessary. the good thing is, i don't have to check them often, and the higher pressure seems to seal better.
     
    jerrymildred likes this.
  3. jerrymildred

    jerrymildred Senior Member

    Joined:
    Oct 28, 2016
    11,490
    14,095
    0
    Location:
    Tampa, FL
    Vehicle:
    2017 Prius
    Model:
    Two
    Try 42 front and 40 rear. I've been running Avid Ascends for at least 7 years on the various Gen 2, 3, & 4 Prii I've owned. I get very even wear.
     
  4. zeng

    zeng Junior Member

    Joined:
    Aug 28, 2021
    40
    9
    0
    Location:
    Kuala Lumpur
    Vehicle:
    Other Hybrid
    Model:
    N/A
    I wouldn't be surprised if the wheel (mis)alignment angles causes wear on either edges.
    Being within the green (zone) isn't good enough I suppose.
     
  5. Peter123

    Peter123 Active Member

    Joined:
    Oct 30, 2018
    130
    126
    1
    Location:
    Los Angeles, CA
    Vehicle:
    2011 Prius
    Model:
    Two
    You might have something loose in the front suspension like a control arm bushing or a ball joint.
     
  6. Kurt Weiske

    Kurt Weiske Active Member

    Joined:
    May 6, 2014
    177
    130
    1
    Vehicle:
    2014 Prius
    Model:
    Plug-in Base
    I ended up replacing my Ascends at 55K with OK tread in the center but worn on the inner and outer sides. I had a tread separation on the highway 5 years ago when a tire had worn, don't want that experience again.

    I'm back to Defenders, loved them when I had them before.
     
    Merkey likes this.
  7. Merkey

    Merkey Active Member

    Joined:
    Dec 18, 2012
    250
    228
    0
    Location:
    Birmingham, Michigan
    Vehicle:
    2010 Prius
    Model:
    II
    I like the Defenders too. At 58,000 now. I will be happy to get 65-70K.