Setting water pump belt tension question

Discussion in 'Gen 2 Prius Care, Maintenance and Troubleshooting' started by pasadena_commut, Feb 21, 2026 at 7:35 PM.

  1. pasadena_commut

    pasadena_commut Senior Member

    Joined:
    May 2, 2019
    2,762
    827
    0
    Location:
    Southern California
    Vehicle:
    2007 Prius
    Model:
    N/A
    Out of curiosity, if one were to loosen the tension bolt for that belt by exactly N turns (whatever it takes to remove the belt), swap on the new belt, and then turn that bolt the other way exactly the same amount, would the belt be at the correct tension? Naively it seems like it would, at least as long as nobody ever readjusted the tension after the previous belt was put on.
     
    #1 pasadena_commut, Feb 21, 2026 at 7:35 PM
  2. PriusCamper

    PriusCamper Senior Member

    Joined:
    Mar 3, 2012
    12,964
    5,275
    0
    Location:
    Pacific Northwest, USA
    Vehicle:
    2007 Prius
    Model:
    Two
    That's how they do it on spacewalks outside the spacestation... They have two different people at ground control to help count your rotations too. Of course when not in the vacumm of space you get dirt and grime and belt wear which can slightly change the number of rotations you need. Also a brand new belt will stretch a little and so a tiny bit tighter would be better than a tiny bit looser.
     
    #2 PriusCamper, Feb 21, 2026 at 8:42 PM
  3. BiomedO1

    BiomedO1 Senior Member

    Joined:
    Mar 27, 2021
    3,994
    2,102
    0
    Location:
    SacTown, Ca
    Vehicle:
    2021 Prius Prime
    Model:
    LE
    The short answer is NO. The old belt is worn and stretched and your assuming the new belt is within millimeters of length of your old belt. Tension the replacement belt per OEM manual/procedures. Don't over-tighten them or your going to have bearing and bushing issues.
     
    #3 BiomedO1, Feb 21, 2026 at 8:42 PM
    Brian1954 likes this.
(You must log in or sign up to post here.)