Separate names with a comma.
Attachments are working again! Check out this thread for more details and to report any other bugs.
If Toyota doesn't have any at the moment, get an AGM in an S46B24R form factor from your local auto parts store. I
Unless the car is lying, P3013 says otherwise. At least you have a warranty to fallback on.
The OP last posted here on Nov 8, 2016. Reading between the lines, he discovered the level in the actual radiator was low so he topped it up, and...
Driving the car a few blocks likely didn't do anything adverse. You need to clear the code. If it comes back you need to look into it further...
Ya pays yer money; ya takes yer chances.
Fairly sure no thread has a write-up of testing and replacing the individual cells of the hybrid battery seeing as they are contained within a...
Which fuse did you pull? It sounds like someone has installed a higher-rated fuse in that spot because it should not melt the fuse holder or...
Why did you pull the negative cable? It will be pointless now to attach your OBDII device to the car as there will be no codes due to you pulling...
That will do it. You need to replace the leaky modules. Any that just had electrolyte transfer from an adjacent leaky module, but not actually...
A leaking module doesn't necessarily have any degradation of voltage. You just need to visually inspect. Look for staining on the battery case.
You will spend way more to implement this than you will save on gas. It's a dead duck now. If you really want 100 MPG, trade your Gen 2 for a PIP.
It is not an up-sell if it is leaking, it needs to be replaced. If you do the job it needs to be done properly so it doesn't leak.
You really need to focus on finding the module or modules that are physically leaking electrolyte. If you find leaking modules, you need to...
I wouldn't bother until the replacement dies. Ensure you undo the terminal nuts quite a bit then use a large screwdriver to wedge the clamps...
Your battery temps are nonsensical. You need to check the temp sensor wire. Either that's broken somewhere or a temp sensor might be faulty....
It is hard to tell what problems you have given that your HV Current is 0,2 A. You really need to do a test drawing (and/or charging) 10 A or...
The repair manual is where you should look if you want accurate information. P0AC0 | Hybrid Battery Pack Current Sensor Circuit...
As far as the meter is concerned you should be good with that but make sure your leads are insulated to the tip. The insulation is usually a...
Check the inverter coolant pump on the left side of the engine bay behind the LF (driver's side in the US) headlight. Touch it and confirm you...
@Esterbrookangela2, no one can see what you write here unless they click on your profile page. If you want to get help with a problem, it's best...