Separate names with a comma.
Attachments are working again! Check out this thread for more details and to report any other bugs.
Gen 1 uses Toyota ATF T-IV and must not use ATF-WS. There is no Gen 1 that should (or can) use ATF-WS. ATF-WS is for Gen 2 onwards,
Yes, remove the old foam and replace it with new foam. When you remove the three nuts that attach the outer rearview mirror assembly, the old...
WIRE, FRAME, NO.2 (No. 2 frame wire) part number 82165-47040 The MSRP is $89.96 but Olathe Toyota has it for $73.77.
Did you also replace the strut tower mounts?
Yes, the three nuts behind the tweeter (called the Front Door Lower Bracket Garnish LH/RH in the diagram below), if that's what you mean by...
The red car icon can appear for many problems–the P0A93 being but one. Reading the codes tells the complete story. Only 2 of the four images in...
Remove the triangle part where the mirror attaches. I bet you will see that the seal looks like a flat gasket. It started life as a ~3mm foam...
What some people call a "turtle" came from the Gen 1 where it actually is an icon representation of a turtle. When the "turtle" appeared it...
So, after the work have you rescanned to confirm what codes you have now? Is it still B2282? Does the CM now work after replacing the capacitor?
+1 @PriusCamper, easily overlooked, but more telling than a static snapshot.
The difference between the highest and lowest block is a very minimal 0.07 V so I don't think you've got anything about which to worry. The way...
The JBL setup has a separate amplifier that sits under the RH front seat.
No, it changes the brightness of the CM, much the same as the brightness control wheel on the US model Prius. There are 3 levels of dimming –...
That button graphic denotes that button controls the display brightness. As Camper said, when that button toggles the speedo display between MPH...
What codes do you have when you read the codes? If you haven't read the codes, that would be a good place to start. There is no benefit in...
Nope, P1121 is likely mechanical with a check of the wiring and connectors involved with the coolant flow control valve thrown in for good...
You can go for either. I can get aftermarket inserts that last 24 to 30 months. I usually change them every second annual service. For some...
This is not correct. The purpose of B mode is to increase the time taken to reach 80% so electricity generation is reduced with the difference...
Once the battery is full (around 80%) it essentially wastes the energy by using the engine configured to provide high resistance, hence the high...
That's what I used to think, too.