Separate names with a comma.
Attachments are working again! Check out this thread for more details and to report any other bugs.
Congratulations Sam. The pot calling the kettle black. If you really were paying attention, you have read multiple times where this situation...
The little glass piece should only ever be cleaned with spray cleaner specifically for mass airflow sensors. Nothing else and never should it be...
Try inserting the nozzle just in by a ½" and turned clockwise till the bowser handle touches the lug on the filler door. Pump slowly and then...
You do not charge the whole pack using hobby chargers. To use them requires removing the pack and opening to get to the modules and there's...
You realize the poster to whom you're replying posted that 2½ years ago and was last on here a year and a half ago? That said I don't think the...
That stinks, I hope at least the original CM (combination meter) failed and it had to be replaced. Possibly. Check: Wire harness or connector...
Possibly you damaged the MAF meter when you took it out, or when you had it out. Possibly inadvertantly. Go through the inspection procedure and...
I don't see how one thing follows the other, can you please explain in this scenario how it is the biggest waste of time? Can you explain how...
In reality, it is not. It represents good value for money for what you get. Consider some "rebuilders" are charging $1.500 for a set of sketchy...
It appears that two blocks are completely dead at ~4 volts. Each block contains 2 modules. Each module contains 6 cells but as the modules are...
No.
As long as you're not preventing the car from going to Stage 4, which it will do after 20-25 min of driving. The car needs to come to a stop so...
Mine is the round MkII charger and the ammeter jumps around all over the place below 202 V. Jeff (from HA) commented about that in one of the...
That's exactly the point I'm making in my last paragraph. Sorry if I was not clear.
There are a couple of blocks reporting a problem with one or both of the modules within those blocks. More than likely at least one module in each...
I just wanted to clarify as I don't think you are comparing apples with apples. It seems you are comparing A) a Maxx Volts (MV) charger with B) a...
What exactly did the auto electrician say? P0171 doesn't necessarily mean the O₂ sensor is broken. DTC P0171 System Too Lean (Fuel Trim)...
It doesn't take that much longer in reality, maybe 5-10 mins longer. It charges very quickly to 202 V, then starts slowing. I see you do regular...
It is not necessarily sadly. P0A08 is a problem in your inverter, not your HV battery. That is 5th in the table below. Check the preceding four...
The above information was accurate at the time of writing but since that time HA has revised the guidance on the termination voltages to: the...