Separate names with a comma.
After getting a JDM engine last fall I have been emptying my catch can at every oil change. It was getting old having to remove the catch can and...
Continental pure contact touring tires. I bought them at Discount Tire. Much better price than the Bridgestone Turanza quiettrack. Similar noise...
The combination of FatMat and sludge has definitely took some of the tire drone away. I would like to jack my car and remove the plastic panels...
Went with FatMat 4 layers thick and Spectrum sludge in the passenger side front wheel well. Figure I need to go big or go home. The combination...
It has the consistency of thin peanut butter and no need to add anything to it. Goes on dark blue and changes to black as it dries. Unfortunately...
I ended up with 3 layers of sludge over the top of the FatMat. The drying time is about 1 and 1/2 hours until it is dry to the touch. The picture...
Busy sound proofing my Gen 3 Prius five. I removed the driver side wheel well inner liner and I scrubbed it down with a mix of hot water and...
I just purchased a set of Continental control contact touring tires. I like them even better than the Bridgstone Turenza Quiettrack. Plus they are...
I have a 2010 Prius 5 with 17 inch wheels and dynamic radar cruise control and several years ago I put in a K&N air filter. I wash and reuse it...
The garage replaced it under warranty with another Duralast and 3 months later the ABS light was on. The internal speed sensor failed. They...
After test driving it I noticed that the front passenger bearing seems to have a bit of a drone while driving. I may just pay to have a garage do...
Are the fronts tougher than the rears? I heard you need to buy a special 32 point large socket to remove the compression nut.
Luckily it came out in one piece. I also sprayed seafoam deep creep on it too to help dissolve the rust and break it free.
Yes. Speed sensor was already disconnected. The sensor is attached with two tiny wires and it would have been torn out if not removed. I was also...
I put in a new Timken rear wheel bearing and hub assembly in my 2010 Prius tonight[ATTACH] [ATTACH] . I used some bolts and washers to pop the...
I changed my oil again and during the winter the oil catch can catches much more watery oil mixture than in the warmer months. It measures almost...
No sure where the pistons were when I did the piston soak.. I used my shop vac and a piece of small diameter hose to suck out the extra BG EPR....
Changing my oil tonight. I trapped 1 and 1/4 inches of oil inside the oil catch can. The oil was still on full after 5000 miles. Imagine all that...
I heard that a few people have put the 2016+ Gen 4 engines in the Gen 3 Prius but you need to do a fair amount of modification to make it work. I...
An independent automotive repair center which my 2nd cousin started. He has been in bussiness since the early 1980's and he just retired recently...
