Separate names with a comma.
Different sites call it different parts, but it's the plastic lip under the front bumper. [IMG] I can't find it for less than $85 shipped. I...
As others pointed out, the timing was off one tooth. Redid the timing and resealed the timing chain cover. No leaks, no codes. Only thing I don't...
Noticed when doing some work near the passenger side firewall, I found an unused 1 wire connector that is the same connector as the 2 horns...
Is this lip or shelf on the inside of the edge of the cover supposed to serve as a "guide" of where to place RTV? [IMG]
Here's the old one with a little over 200,000 miles on it. You can see it has started to wear. [IMG] Looks like either a casting issue, or...
Does the ECU only send the 5v signal to the crankshaft sensor once ignition is detected? I did not have everything together last night to fully...
Engine was installed in time. No slack in timing chain. But here is what I discovered... [IMG] Piston #1 is set to TDC, cam marks and chain...
I can't seem to find it.
[IMG] It looks like the bottom of the timing chain cover, but then I saw a bit on the area and bolt above it. Don't see any drip down from the...
Prior shop installed all new tie rods, lower control arms, struts and ball joints. Now when making sharp left or right turns, the ball joints are...
Before I got everything back together I had to put the front sub frame on so it could be towed home as I was going through a divorce. Factory...
[IMG] Is this part absolutely needed? I know the brake dust shields rot away in salt land and people run them without them fine. Supposedly...
I hate how all bearings besides the OEM are made in China now. Ordered a "F@G" brand (actual name, German company), and returned it because the...
So from reading on here, I've seen a post where the ECU can set this code when in reality it meant to set codes P0011 or P0012. The engine was...
Bottom mounds installed. I used stainless hardware. [IMG] [IMG] Upon removing what was left of the old fan switch, the pins were still in the...
A lot of online Toyota part sites only show this: [IMG] I found this: [IMG] Here are the part numbers. The 8 bolts that hold the individual rad...
The 1.5 Engine used in the Prius C is pretty much a Gen 2 engine with some changes, but the intake manifold itself will bolt right up. The...
Replacing the old one, the new one does not any hardware to hold it together. There should be two nuts installed on the top and bottom to hold it...
Personally I think the entire Gen 2 throttle body design is goofy as hell. Why? The throttle body in a Gen2 Prius is pretty much the same...
I replaced my radiator and accidentally broke the old one. Both coolant sensors are under $10 at Rockauto. The fan switch is $75! It looks...
