Separate names with a comma.
It's always better for you to sell it to a private party, not the dealer.
Toyota has had this criterion for strut replacement for many years. My 1989 Corolla manual had the same visual leak test. I replaced them anyway...
On some years there was a recall from Toyota on a steering component that could cause play or creaking noises. This might be a safety issue, and...
I buy them at the dealer once a year. They outlast FLAPS inserts. In SoCal the problem is ozone and UV and heat. Clean with good spray glass...
Is your 2008 still under warranty?
Check the link above on how to fix the likely root cause: corroded sensor. Cost: labor plus a hardware store spring.
Do you have a source for metal shims? I am not confident the plastic ones will stay torqued down properly.
The notice from Honda specifically states it is to prevent battery failure, and that the gas engine will operate more often. This can't help but...
How are they aligning the rear? It can be done with shims or a Toyota custom prybar, I am told. Given my local dealer's lousy alignment skills...
This is not universal. Manuals for other cars always use negative numbers for negative values of camber and toe.
In seeking the best mileage, Toyota specs seek minimum friction. Lack of front caster is another contributor to low friction (under dynamic...
Since the number is positive, is the rear toe-ed IN or toe-ed OUT? On most cars a (very) little toe OUT at the rear makes it more stable. If your...
I connected my combo slow/med/jump start batery charger to the front (underhood) connector on the trickle setting (1A or less), then removed the...
And if you use a luggage tray, it's a good idea to use trailer lights on it.
No, the inverter coolant pump runs continuously, so it won't shut off when the ICE starts.
Isn't the red triangle for the 4-way flashers supposed to light up? That used to be a US federal safety requirement.
Not THAT serious!
What a rip. Obviously the auto industry lobbyists have been busy gutting the rules that were to eliminate this "dealer only" or megabuck scan...
ScanGauge worked while my AutoXray OBDII scanner failed to read on the CAN bus. But as posted, only the DTC codes themselves. How much does that...
I have a Scan Gauge that reads out the DTC codes after the MIL light on the dash comes on. However, it does not seem to read out the "INF"...
