Separate names with a comma.
Turns out both of my SRS sensors in the footwells were loose. Oops! Plugged both in and all errors went away. According to TechInfo, both turn...
Grabbed a bluetooth OBD2 scanner and Carista. Looks like something happened to my front left airbag sensor, so I have to figure out why since I...
The lights haven't gone off yet and I've put 40 miles on since disconnecting the battery so I'll try to reseat the k16 connector today/ tomorrow....
I have to reassess how I get to the PDBA, because it's pretty back there. Is it possible to drop the entire ECU mount to get better access? I...
The 2 sky blue wires I tried tapping.
Yes, I'm on a FWD HEV Limited trim, with all of the tech add ons except for a dash cam. The pinout was correct on the old door , but a handful of...
I have the right mirror assembly installed. Unfortunately I didn't realize the outer part of the mirror is wide angle so I gotta swap mirrors now....
Welp, time to figure out how to negotiate the pin out of 9 with this depin kit!
I appreciate how much information you've been given me. I'm just mapping everything out and preparing pins to make it easier, so I'm coming across...
Am I reading these notes wrong? I feel there's discrepancy on the pin locations: Door Side New 1 MV Red | 9 MH Lt Blue 2 |...
Ideally I'd like to not have to drive to work with my car in that state. Hoping to physically install the passenger side mirror and run the new...
I'm looking at the diagram for the wiring. When you say to pull the dash, do you mean just pulling all of the panels on the bottom side of the...
Perfect! This should let me repin it pretty easily! Image for posterity related to this post. B/R and B/G indeed mean Black/Red and Black/Green
Do these diagrams directly translate pin for pin? I'm preparing to install the JDM mirrors, so I want to review the repinning I'll need to do on...
Does anyone know the wheel width + offset we need to stay within to avoid rubbing issues? I just ordered some Enkei RP03 in 18x8 +40. I saw...
$8 depinning tool to the rescue! Didn't need any modifications to get it out in a jiffy!
Here's a close up of it. I ordered a depin set, hopefully 1 works as is!
Yeah I found your post there and was hoping all of the information was there. Is this from the back of the connector or that hole at the top of...
Was able to depin the 16 pin harness easily. This camera connector is quite a problem though. Got any tips on how to depin it?
Was able to remove the lower piece successfully! Looks like I'll need to depin these to remove them from the arm assembly?
