Separate names with a comma.
The voltage wasn't oscillating at all, nor was it oscillating over several minutes. It was continuously going down.
Because of Prolong's advice, found in their FAQ's, "Even if one were to have to eventually replace part or all of the hybrid battery, a Prolong...
It's on a 2012 V with 40K miles. I've discharged it twice and charged it about 6 times. Unfortunately, I can't discharge it right now since I need...
Has anyone else experienced their voltage going down while using the Prolong charger? I am in the process of charging the battery. After...
I bought them in May of 2013.
P195/65R15 $300 Cash Local pickup only. These were used for summer driving, stored in the garage, and have 8/32" tread on them....
I ended up drilling and tapping mine out then replaced with Phillips screws. Was really easy to tap out.
Did you use a torque wrench on the intake manifold?
Just to clarify, are you're talking about the throttle body bolts (7 ft. lbs.) or the MAP sensor stud bolt (44 in. lb.) or something else?
Took the car to run some errands today and it runs much more quieter and smoother than before. Here are some pictures from the cooler I took off...
Success!!! I just went out and put it in maintenance mode. It sounded rough but not as bad as before. About 30 seconds in, the car revved to...
Too afraid to try to drive for fear of it stalling. How would I clean the intake ports and unclog the injectors?
Yeah, unfortunately, not my first rodeo! EVAP purge valve all good. Didn't do much as far as checking the fuel injector harness. Nothing seems...
I get READY mode, no problem. It's just that it's running very rough like revs up then down and sounds like it clunks. No check engine light...
Which app is that? I have no codes after disconnecting the 12 v battery. What is the EVAP purge valve?
Yes, manifold bolts were torqued as you stated, but I didn't use a torque wrench. I have an old torque wrench & don't trust it since I'm sure it...
I'm afraid to clean the original parts for fear of adding another variable. Plus, I'm pretty much ready for this to be over. Taking this apart one...
I'm thinking before having it towed, I will lastly put the original dirty parts back in, see if it works, and call it a day. Hopefully.
Unfortunately, the impact screwdriver stripped the heads. Yes, all gaskets were double checked for proper seating. I'm aware of the Japan...
The used parts came from low mileage vehicles and were not that dirty, but I cleaned the cooler and pipe anyway with repeated oxyclean hot water...
