Separate names with a comma.
Upon further thought, you can cut a piece from the plastic top of a margarine tub or coffee can lid, punch some holes in it and use wire ties to...
Sure. You just need to cover all the conducters on circuit board that might contact any part of the Prius chassis. There's plenty of clearance...
Look at the 1st 2 photos I posted on page 10. I used non-metalic type of duct tape that has a cloth substrate. Covered the whole circuit board,...
What do you mean tires are 8 & 10 lbs? Tire inflation pressure should be well above 30. See the label on the driver door frame. I can't believe...
Either will work fine. Are you using a circuit board?
You can use a 2n2907 for the PNP. Might be easier to find. Any PNP that's good for 0.5 Amps max collector current and greater than 25 volts...
Yes, he was able to use 3 wires because the power return (gnd) on his camera was common with 1 of the video signal wires. He was able to figure...
My post on page 10 definitely works and I also recommend the installation by Willco on pages 11 and 12. They work like the factory install. Shift...
What OBD Bluetooth device are you using? I've been trying to get "Torque" by Ian Hawkins to work with my Android tablet (Sanei N-10). The tablet...
The backup lite wire is accessible through the pull out panel in each side of the trunk area. I did this early on thinking I was going to connect...
I've thought about this as well, but satisfied with what I did, so I won't experiment any more. BUT if I did: I would try the 43 ohm resistor...
I now have 5000 miles (6 months) on a 2012 Prius Two after having driven my sister's hybrid Camry San Diego/LA roundtrip and San Diego/Las...
I think the CCD cams take 70-100 mA. It looks like your resistor carries 300 mA. Might want to cut it back to 150. 33 ohm should work. less power,...
Willco, are you the guy with the ICM-1024? We're dinosaurs. I did some random research on Prius Chat. The diode arrangement derives from a...
Just checked out your report. The 2 indents are just to the inside of 2 little tabs that hold the lens on. Use a 1/8 to 3/16 screwdriver blade and...
Yeah, I wanted to get the light loose, but couldn't figure how to do it. Gotta hand it to you. SMT mod to the camera and tie into the roof wires....
Willco: How did you get access above the headliner? At first, I intended to connect in there. I popped the 3 pins and the left side panel as well,...
Wow! A guy who does surface mount work. This certainly is the most elegant solution. Congrats. I returned to see what was happening with this...
Thanks for this great post. Explains the power distribution and partitioning in an understandable way. Reads like the answer to the question asked...
