Separate names with a comma.
I assume that is the SKS button that you refer to, that turns off the SKS system. The blinky light will still be there, as it is a function of the...
What is known about the specs for this pump? Flow rate? About 2A current draw. I'm not suggesting using an aquarium pump or anything, but in this...
The economic factors change quite a bit if you DIY. Given the that dealerships have turned to making money on repairs rather than from selling...
Maybe that switch is extra noisy. I don't hear anything when I press the brake pedal, other than the actuator pump.
A shorted cell is a random event, and is dependent on sulfation level of the battery. A small bit of sulfation can cause warping of the plates,...
I think is normal to see state of charge variations in the coarse of a day or two. The battery ECU has to guess initially. Temperature change will...
There are many of these cases reported, so it is not a particularly isolated event. I would not think that just wiggling the wires is going to...
Hi. To make the headlight leveler be manual, wire a potentiometer to the headlight beam level ECU, which is under the dash on the far passenger...
They are in the fuse/relay block on the right side of the engine compartment. In the manual, it's Unit B of the Engine Room R/B and Engine Room...
This is a standard 3 pin connector, and it ought to have a boot covering since it is under the car. There is a retaining lever that holds it...
If you have a laptop, and can wait a little bit, I suggest to get one of the "mini vci" units from eBay. ~ $30. It will scan the GenII just fine.
The relays are located in the black plastic boxes under the hood. The brake actuator is buried behind the inverter, under the wipers. Hard to see....
We're grasping at straws here, obviously. Check the fusible links under the clear plastic cover, under the jump start terminal. They should all...
Does it go into ACC mode, i.e. Push start but no foot on brake?
If you can get an assistant to help, use a voltmeter to monitor the voltage on the 12V jump start terminal under the hood. Try starting and see...
What kind of new battery? There are reports of "new" batteries being delivered with no charge. First step would be to check the voltage and be sure.
I would guess that there might be some air left in the system that still needs to be removed. I have seen some posts that indicate that even the...
There have been a few reports of new Optimas being delivered with low charge or faulty. What is the 12V reading? Those error lights can be a...
OK, does it happen when the car is off, or only in Ready mode? If you can get an assistant to help, maybe you can localise the sound better, to...
The red triangle indicates that there is a significant problem with the car. You need to get the DTC's read by an OBD2 code reader, preferably at...
