Separate names with a comma.
Bob, I changed my mind on the momentary buttons, they could be pressed at the same time causing who knows what. Stay with the three position...
Only use ISO-9141 and standard OBDII on the gen1. I have found that with anything else it will spike pins 6 and 14 while doing its mode query, in...
Check the 100A DC/DC fuse in the fuse box next to the inverter, take a voltmeter and measure both sides of the 100A DC/DC fuse to ground while in...
Hi Bob, yes it looks like all that's needed is a single 2pole toggle switch with center position open to read and clear codes. So the "can" lines...
Ok I went through and verified both cables and here is the result - the gen 1 doesn't use the "can" pins at all, they are disconnected in the...
Hi John, I have a question: have you ever cleaned the throttle body and MAF sensor? that happened to our 03' and it was terrible with the lights...
Hi Vincent, I have tried both BTA and SOC(passive) on the 06 GEN2 and it doesn't work either. SOC just stays blank. I think it was tested on an 05...
I also live in Longmont, CO., and have AE software to read any codes that may come up for you. It'll save you $$ instead of the dealer $100+...
Good idea Bob, I will have to sit down w/both cables and buzz them out. I don't have the car during the week -mostly late week or weekends. Will...
Thanks Vincent, so noted, and thanks Rick, I got the new cable this week and all works good now with the 03', no more unplugging and plugging in...
Right, good point jk450, that is a huge difference. Here is a plot I did a while back on our 03' where I recorded the starting voltage sag on the...
by jk450: "Ideally, you would use your Autoenginuity to take a snapshot of the process. What are the voltages after you try to start the car, and...
No the Toyota procedure is probably not in error for a typical mechanical person with no knowledge of electrical - this is typical of the...
Ok Dirk, well that delta is slightly over 2V (hi block =15.39 and low block =13.25) I think the HV ecu would not try to start the ice with that...
Make sure the engine oil is not over full mark, and check all other fluid levels, other than that you're good to go. That is assuming you had the...
There are capacitors inside the inverter that can "hold" a charge for a rather long time. Wait an hour after "opening" the center of HV battery...
"I am also able to view Bta and soc at the same time with no complications also have the scan rate set at high" That's pretty cool rick, I will...
Thanks rickw - I contacted them today and they are sending the cable. And thanks vincent1449p I'll add that to my Gen1 xgauge list.
Thanks , do you remember where you called for the scangauge cable? I have looked somewhat but have not found where to call. Plenty of places to...
Ok on the enginer kit still being Beta status, sorry the converter went south. So is the voltage output adjustable to handle the GEN1 or GENII...
