Separate names with a comma.
If you know it's the hybrid traction battery, just take it out and get one of those reconditioned battery packs for less than 1500. They sell them...
Hi Bob, Well it works if you just plugged it in and started for the first time. It's when you turn the car off, but leave the scangauge connected...
Ok I have done much experimenting to find out how to get the scanguageII to reliably connect to the GEN1 Classic Prius (we have an 03), and I have...
Ok Bob sounds good for the next round of data here. I will have the car back again mid week, but plan on recording both MG1 rpm, A, W, Temp in one...
Bob, Given the irregularities in live data, and the fact that MG1 also goes into charge mode regularly depending on conditions at the time, the...
Great job Bob, Yes I would have to agree with plot #3 the most, but #1 makes no sense at all. Hmmm Will have to try this one.
Hi Bob, Yes there are drop outs in data however the general trends are there, so you can just fill them in. Since the data requests are time...
Here's one last shot of the cold start, initial charge and then starting to drive. You can see the charge right after ICE start, from 138 to 148...
And a shot of the 03 Prius Batt ECU Hi / Lo block voltages filtered, and zoomed in on some accels and regens from coasting and braking. Of course...
Here is a zoomed in shot of the cold start voltages and then starting the ice. You can see the voltage sag from startup, then it immediately goes...
Here is the filtered version of the last shot. There are many more good data points to keep the trend accurate. When one goes to "0" just fill in...
Here is a plot of only the raw hi and Lo block voltage from the 03 Prius Batt ECU during cold start to driving.. As can be seen there are three...
"I just turn it to IGN but not READY. This brings up the ECUs so I can capture vehicle startup states. A little rough on the 12 V battery but...
Bob, Concerning :Hummm, so the operational scenario is: connect ProLine to laptop USB boot laptop start AE with communications set to...
I'm sorry you're having that problem. I have not seen the "triangle of death" from AE yet on the 03, only from scangaugeII using xgauges. Just...
Bob, I have seen this about MG1 torque values being bonkers. I think part of this is that it remembers the last value if not updated recently. Now...
Vincent, Ok on turning the key slowly, will try that first. Good thing it goes back to normal after unplugging.. Yes I also suspect if you change...
Sounds like a good one to plot . So you think by having too many parameters to collect per cycle, the software/hardware can't keep up so by...
Thanks for all those Vincent. I tried it again on the 03 Prius, and it works fine until I turn the car off. Then next time you startup, it will...
Incidentally, I also noticed that you cannot actually record the "cold" block voltages since you must first start the car in order to connect to...
