Separate names with a comma.
I took vertex's advise and disconnected the 12v. I booted the car back up to find the dash lights still on (minus the yellow triangle), and mfd...
I thought of that too, but I'd imagine I wouldn't get the "problem" and red car on the MFD.
I am not able to move the car at all, so I guess I'm not able to get into READY.
No, it has gas, almost a full tank. I wish it were that easy. :) Aren't you at least able to move in EV mode without gas though?
55K on the odometer Not sure if the 12V is original or not as I just got the car last year. IGN off has the 12V @ 12.3ish so it is low. With...
My wife had some problems yesterday with the Prius. She was driving home and the cruise stopped working. I think at that point the VSC and...
Nope, I just haven't gotten around to doing this yet.
You are correct in your assumptions about my kit. I replaced the L5 set. I have not done any charging yet as I figured I should balance first....
Alright, I got the new batteries and put them in the pack last night. I then threw the balancer on it. It will be chugging away for a while...
Haha, nothing all that special. Still rolling on the stock wheels. But, here ya go. All mounted up. I started to put them on the car one...
I ended putting a 2x4 up against the rim and wacked it with a small sledge. A couple of swings and it broke loose. Now I have all 4 Ecopias...
I also got a set of steelies off of a Celica that I found CL a few weekends ago for $120. Looking forward to putting some Nokian LRR snow tires...
I got the Ecopia's on the Prius last night for the most part. I got 3/4 of them on at least. The last steel wheel I couldn't get off of the car....
Thanks for the warning about the celllogs. That is a bit concerning. I haven't kept up with Jacks videos, but I know I want high voltage...
How does he monitor charge/discharge voltages?
FYI, Jack responded quickly. He asked I get a voltage reading on all cells to make sure the rest are good. I checked them all and all were good...
The picture was taken after loosening the bolt. I was very careful to make sure to check that all bolts were tightened down upon installation....
I went to install my automatic disconnect circuit into the Prius today. I quickly found that it was going to be a big pain to do with the kit in...
Haha, that figures. I will finish it though. My setup will have also have a low voltage cutoff.
Well, summer is on its way and its getting closer to the point where the summer wheel/tires can be put on. I noted when I first got the Prius...
