Separate names with a comma.
Not exactly the whole story. On discharge a weak or low capacity modules voltage will drop farther and faster than its stronger pack mates....
The bad news is that the warning lights are still on because I broke one of the temp sensors that clip on the bottom of the cells and now the car...
Ok, you guys made me actually weigh a Gen II battery. It came in at 85lbs. I like the two by four trick. I do allot of battery work and use a...
Be careful not to confuse HV leaks and fluid leaks. HV leaks are voltage getting to where it should not be. Fluid leaks could be rain water or...
Check out this thread for a P0AA6 code. Did our transmission just go south? P0AA6 | PriusChat On a Gen II Prius a HV leak will cause the symptoms...
The P0AA6 means there is a high voltage leak. The likely causes are the HV battery, the air conditioner compressor, or the transmission. Less...
Exploded modules are almost common. I have seen cars run on topless modules. The explosion is just built up gas pressure cracking the plastic case...
Just to be clear. There is no such thing as an "after market top line battery". Toyota sells new batteries. Everyone else sells batteries...
You could try putting your original battery ecu in the Doorman battery. What do you have for a code reader? Brad
No need to be concerned about replacing the battery. You should PLAN on replacing the battery soon. Sitting unused is much harder on batteries...
The only tough part of replacing a rear wheel bearing is that they tend to rust in place. Use your favorite penetrating oil. An air hammer can...
I have to call urban legend on this. I have never seen a code from a .3 voltage difference. I have never seen a post from anyone that has seen a...
After disconnecting the 12 volt battery TWO pushes of the power button are required to start the car. The first push will light up the dash as...
Just to repeat one more time the proper installation of the orange safety plug. Push the plug in, flip the lever up, push the lever down. The...
Hi Roy, Any thoughts on how the re-hydrated modules are performing? Did you use first or second gen modules? Have you done any capacity testing? Brad
What Bob said.:( I believe that for anyone that does not do their own repairs a new car can be cheaper in the long run. Someone that does do...
Ok, our disagreement is just a matter of wording. My dischargers stop at .9 V per cell. So set at a 6 cell module they easily catch a dead cell. I...
Sure they are, but it is still a lot of work to put one in. jbfla 1300, Try contacting Tampa Hybrids. He posts allot here and has a small car lot...
I have to disagree. Modules with one bad cell are easy to catch with an RC charger/ discharger. Most RC dischargers will terminate at 5.4 to 6...
16 pin. You can get the cable quicker from US based sellers. They generally cost a little more.
