Separate names with a comma.
What kind of headlights are those?
For me I counted 6 complete rotations. Are you using the correct 12x1.5 thread pitch fasteners? what lug nuts are you using?
As long as your spacers are 3mm, you should be getting about 6 turns. Don't forget the wheel and spacer will compress some after initial torque...
The article is quoted as stating the same engine code designation as the gen 3
Agreed. Don't do it. Do Professional Lexus. See the link in my sig.
Someone translate this please! I want to know what the above picture says. Anything on torsional rigidity? Or amount of high strength steel used...
It looks nice. I'm starting to like the rear end more than the front now... at first it was the opposite. The front looks a bit unfinished/rushed.
I wish I could read Japanese. Whats the fuel economy? I'm American and don't know what liters are... too lazy to break out a calculator. Looks...
You guys might want to check out my professional Lexus HID retrofit. See my sig. Uses all Genuine Toyota/Lexus parts (except for the dual relay...
I think the OP is talking about a squeak rather than a rattle. A rattle is caused by vibrations. A leg resting on a panel would cause a squeak....
^I want to lower my car just to close the wheel gap ever so slightly but the TRD springs are a bit too low. I wish they were just a bit higher....
I'm using a dual relay setup as well and recommend it. They are only $17 pre-made and look fantastic. This one is a bit more but you can...
I recommend Professional Factory Lexus. See the link in my sig. The proper way to get brighter lights vs. slapping a generic cheap chinese kit in.
In addition to all the stuff posted, the Gen 3 is more torsionally rigid too as well as having superior crash performance in the newest small...
I'm sure someone addressed this already but the DRLs at night would be way too bright creating lots of glare and stray light. This is dangerous....
Hankook Ventus S1 noble2 I got them cause they had a great deal and rebate. The description reads they incorporate a special formula to...
If keeping the same size tire, I highly doubt you'll be taking any detectable hits using a quality tire such as Michelin or any brand for that...
I installed a $7 painted one from eBay. Works and looks fine. It had to be modified and it barely fit. I'm talking fractions of a millimeter snug...
I disabled the Tire Pressure Monitoring System by spicing 12 volt power into the signal input wire. Works great.. took me a while to get it...
I would say go Professional OE Lexus like I did. Click the link in my sig. Very good professional results!
