Separate names with a comma.
If I have to start the car to bleed the brakes I assume I'm going to get errors in the system. Is that going to screw me. I read a lot people...
My 2011 Prius had the rear brake lines disconnected (changed rear axle beam) so there is air in there but I don't think there is a lot but I have...
So, I've got a replacement beam in the mail and getting things figured out...I'm reading that I have to do a "Ya Rate and Acceleration Sensor...
I think the beam is the main thing. I'll go through the entire vehicle again but I don't think anything is that rusted. Clearly I didn't check...
All the damage is rust. The bottom rotted and then it eventually cracked. That's some amazing resources. Thanks everyone but if @MrPete is still...
Hello everyone, Last night my 2011 Prius decided to practice Karate. Took a look at it tonight and it seems like the rear "control arm" is...
@Tombukt2 : Sorry...I'm not clear. Are you saying it worth it for me to change the part they reused?
Just to close this thread...I picked up the vehicle today from the dealer. IPM, MG ECU, current sensor and wire sub assembly have been replaced...
Thanks for all the great information everyone.
Yes. I qualify for the IPM but the dealership can't tell me if I meet the criteria without looking at it first (of course). They don't have any...
@bisco : Just checked, 12.68 when the car was off, when on 14.4. Does this rule out the inverter? But it doesn't rule out my IPM? Is that...
@bisco : So the fact that it is charging rules out my inverter? But it doesn't rule out my IPM? Is that correct? I'm just using a bluetooth obd2...
Ok. I took a screenshot of the codes (and left them in the system) and I guess I will just wait to have the pro's look it. I did drive it for a 10...
Hello everyone, So while driving early today I felt a lurch, got the the message "Check Hybrid System" on my display and my 2011 Prius went into...
@Tombukt2 : We call it Cattywampus where I'm from...haha
@Mendel Leisk : Thank you for the very clear information!
Makes sense. I will make sure the pads move properly. Thanks for clarifying.
@ASRDogman : Sounds about right. Does the front have the same setup?
