Separate names with a comma.
So, you have a few things going on here. P1121 is almost always set by a failing coolant control valve (or "3-way" valve). It controls the flow...
Have you checked if there is adequate refrigerant pressure in the system? Car won't turn on the compressor if all the gas has leaked out. Posted...
What Tom said. The most common cause for P0A84 is corrosion at this connector. There are cracks in the seam sealant around the upper corners of...
Was the car powered on to ready or ignition ON? I believe those 5 ecu's are the ones that will report even if the ignition is off. Posted via the...
Maybe you own a Gen 2 that doesn't have SKS? Or you do but the fob doesn't work properly (or wasn't programmed, etc). Posted via the PriusChat...
What does the scantool show for A-F sensor voltage and short - long term fuel trims while driving normally? Normal A-F voltage is around 3.3V. It...
So, does the car go to "ignition on" or "ready"? Does the engine run? If it does run, did you check all the fuses (underhood and underdash) for...
It's been 10 years+ since I last used AutoEnginuity, but it was a fairly good "budget" pro level scan tool. If you can go into the HV battery ecu...
I see it now and again on some Toyotas or Hondas when they get over 10-15 years old. Not very often, but it happens. Usually I can fish the...
.
Also depends on the quality of the belt - all rubber is not created equal. .
If pushing on the brake pedal has "no effect", then there are multiple problems with your car. Usually when you step on the brake pedal, all...
That scantool is the Launch X-431, it says "pad 2", but Launch has a few dozen (?) sub variants of X-431. If you want a "complete" budget...
If you do not have to go through state emissions inspection, then ignore the "check engine" light. Otherwise, no. Toyota designed a few...
If you see negative voltage readings, then there is a problem with the voltage sense circuits. If you have replaced the sense harness ( & properly...
The Maxisys is a pretty good scantool. You should have bidirectional controls with that and can do things like command the fuel pump on (does the...
Here's the connector.[ATTACH] .
As Brian pointed out, cracked body sealer around the top of the tailgate hatch frame lets water leak in. It usually corrodes a white connector...
Here's what the tool shows when I pinged my fob. I'm not a locksmith so not sure what kind of data it should be showing.[ATTACH] Posted via the...
Here's the AM2 fuse, and the connector that will disable the inverter water pump as mentioned.[ATTACH] .
