Separate names with a comma.
Attachments are working again! Check out this thread for more details and to report any other bugs.
It's not the pump. I'm familiar with that sound, and this sound happens when the car is moving. doug
I don't think it's the CV joint. There isn't any weird noise when turning, and I can't detect any difference in the sound that is dependent on the...
The CV joint boot seems fine, and I didn't feel any play when I tried shaking the shaft around. Are there any other ways to test the CV joint?...
I have a whining/moaning noise from the front (left I believe) of my '09 Prius. I know it's not the wheel bearing because I changed that and...
Indeed, excellent info! I, too, ordered from this supplier and the cost at this time was $160 including shipping. Delivery was very fast, and...
Update! I found the method on this page Undocumented Custom Menus on the 2004 Toyota Prius The method is to get to the Diagnostic Menu, as above...
Yes, I have already tried that. Unfortunately, I'm not finding the part. Maybe it's a "touring" edition part that I'm not finding the right page...
It is the plastic trim piece at the bottom of the rear corner of the Prius Touring. It is (if it were not missing) about 15 inches by 8 inches,...
I replaced this valve with minimal coolant loss. All seems well with that fix. The problem was that I then had all the brake/ASC/ABS warning...
Well, I used the techstream program to run the recalibration of the Linear valve. That seemed to go ok, though I had to leave the parking brake...
Ok, I'm back from travel and have got Techstream working. on the ABS/VSC/TRAC section the codes I find are: C1203 Engine Control System...
That's very interesting. I used ramps on my sloping driveway, so the front of the car was significantly raised. I wonder if that is the common...
Coolant's good. I've not got the red triangle, just the brake-related stuff. Thx.
Well, I dug out my trusty Fluke 87 and gave it new batteries. A careful voltage measurement shows 12.49 switched off, and 13.92 "ready" and, 13.98...
It seems that the speed sensor wire exits the wheel well really high up, more like in the region of the main fuse/relay box. I've been looking...
Ah, sorry, I forgot to mention that I did that. I unhooked 12V negative for a few minutes. No change. Doug
Hello all, Today I replace the coolant flow valve to cure a 1121 code, and related check engine light in my 2009. After following the advice of a...
