Separate names with a comma.
Attachments are working again! Check out this thread for more details and to report any other bugs.
Long story. About 2 years ago I replaced the ballasts and headlights in my 2007. They were these ones and they worked great until I wrecked the...
Alright so I've been reading up and I think I understand how this all works, but I may be wrong. I have a 2007 with the HID's. Long story short I...
Well that makes me feel better! Thank you! I'm charging it back up right now and hopefully by the time I get off work today it's ready for a...
Alright so I ran into what I think could be a big problem. I got off work and set up to discharge with 2X 200W bulbs (first discharge cycle). I...
Tested the blocks with the OBD, and each block is at 17.1 or 17.2 (varying) Except block 3 which sits at about 17.3 and consistently is .02V above...
Alright so I tested the 12V this morning and it was at 12.2V after sitting all night, so I don't really think it's done for, but probably low,...
I will test the voltage on the 12V manually with my voltmeter tomorrow morning. The headlight method tells me it is at 11.9V resting. I fully...
1. The 12V is about 4 years old (the original lasted 5) and shows its about .7V lower than what I've read it should be at. I just tested it with...
Hello again! I have replaced the 2 bad cells, and the wire harness. I reconditioned the pack. Everything went very smooth. But after driving the...
I wasn't talking about the grime on the gen1 because that was covered nicely in this post already. If you have too keep it submerged for 2 hours...
I found a tip online that worked like magic. Literally, I was freaking out. My bus bar copper terminals were VERY corroded and tarnished. I popped...
I found a wire harness on Ebay for 25 bucks, and picked up 2 modules for 30 a piece. After shipping it was like 115. Not as bad as I expected, but...
Well I'll scrub em up and see if I trust it. I'll post pics after everything is scraped and cleaned before I put it all back. If anyone thinks...
So when putting this back after replacing a module my uncle apparently didn't tighten ALL of the bolts. One of them was lose and did this.. So the...
I get I'm avoiding a $3000 dollar repair (which is only about half that unless you go through the dealer). And I purchased necessary equipment to...
Where can I find a fairly simple guide to build my own load tester? I already have 2 voltmeters so I don't want to buy the load tester from Jeff...
So why can't I run Techstream on Windows 8? And do I have to run on 32 bit? Or do they offer 64 bit versions of the software and hardware? And...
Can I measure the mAh of each cell with an OBDII or do I need to get the a mini VCI to do that? I thought measuring the voltage of each cell under...
I don't want to dump more money into this thing. Win 7 Laptops are hard to find, and even at that they are like 100 bucks. I just spent 400 on...
Bad news... I was driving to work today, and the lights all came back on. I barely made it to work, it was accelerating very slowly, and I'm not...
