Separate names with a comma.
Attachments are working again! Check out this thread for more details and to report any other bugs.
So I have the 2003-2006 Toyota Factory Repair Manual now...where are the ECU reset procedures, because I can't find them anywhere?
Thanks for the insight, but again the post was primarily to highlight that non-volitile memory exists for calibration settings, so I was...
This isn't about the ABS system, its about the fact that the ECU DOES store certain things in flash despite disconnecting the 12V. It's possible...
@TheLastMojojomo I found this when searching for ECU reset procedures, this guy had a problem with his gen 3 storing brake ecu info DESPITE a...
Another thought...I used Dr. Prius to clear any logged engine codes (after the 12v reset) in the ECU just to make sure it wasn't holding onto...
An interesting observation in the torque pro app earlier today (now that I know what I'm looking for): sudden pedal depression up to 59% will...
So glad I came across this...was averaging 49mpg mixed city/hwy Winter driving, 54mpg summer. Got a code in October, realized my air/fuel bank 1...
Updated to a very old thread...haven't seen P0420 since clearing codes a while last year but now see P0137 on occasion with lower MPG, average...
It was a Denso model 234-4623, purchased from Amazon and it was direct from Amazon not a third party. Only replaced the downstream o2, not the...
2005, check engine light tripped code P0420, research points to bad catalytic converter or o2 sensor...50/50 city/hwy MPG is 53 per tank. Thing...
Charged overnight, just got done from an hour drive running her hard, sat idle in park for a few minutes to let the pack settle...anyone have any...
Using a meanwell 350ma 257v power supply to trickle charge my pack, have it all wired up, but testing the 300v 10a voltmeter I purchased seems off...
The idea for me is to get as close to factory new spec as possible so a. It is as efficient as Toyota engineered it and b. The engine, cooling...
I appreciate the advice, and based on the suggestions by folks with what seems like a lot of experience I will take my time researching a bit more...
The reason I wanted to open the pack was because of the measured internal resistance being out of spec, the fact that there was algae and moss...
Here's some pictures of the outside post detail, you can see the fender that will need replacing eventually, some pretty decent chunks out of the...
Still haven't started rebalance, waiting for some parts to arrive to connect to the meanwell power supply... Spent yesterday using a orbital and...
Just did that...ECU update in 06', recall 60C (??) In 06', recall 90L pedal modification in 10', A0N REPLACE HV ELECTRIC LSC in 11' (inverter...
Good point...what about maybe just spraying CRC contact cleaner on the posts and bus bars and a light wire brush scrub without removing them?...
Update: cleaned the MAF sensor and throttle body along with replacing the spark plugs with new NGK ruthenium ($11 each, oof). Noticed some rat...