Battery Module/Block Identification

Discussion in 'Gen 2 Prius Technical Discussion' started by chevsen, Oct 9, 2014.

Page 2 of 2
  1. Rodger C.

    Rodger C. New Member

    Joined:
    Apr 28, 2020
    8
    3
    0
    Location:
    Lancaster
    Vehicle:
    2009 Prius
    Model:
    Base
    I swapped modules from my Gen3 over to my Gen2 since they were going out. How could I know if I put them on correctly?
     
    #21 Rodger C., Apr 29, 2020
  2. ilbdarned

    ilbdarned Junior Member

    Joined:
    Sep 10, 2020
    4
    1
    0
    Location:
    Arizona
    Vehicle:
    2008 Prius
    Model:
    II
    You think someone might be trying to make them harder to fix, I do. I recently had a cam position sensor go bad on a Hi Feature GM 3.6 liter, the scanner said bank 2 exhaust sensor was bad. Most bank 2 sides of the motor do not contain cylinder #1. But on the GM high feature, the bank 2 is on the side with the #1 cylinder. Just backwards than most all other motors. go figure
     
    #22 ilbdarned, Oct 25, 2020
    Mendel Leisk likes this.
(You must log in or sign up to post here.)
Page 2 of 2