1. Attachments are working again! Check out this thread for more details and to report any other bugs.

Help with ECU connector pin removal

Discussion in 'Gen 2 Prius Technical Discussion' started by CruZindon, Apr 30, 2011.

  1. CruZindon

    CruZindon New Member

    Joined:
    Apr 3, 2011
    52
    1
    0
    Location:
    Irvine
    Vehicle:
    2008 Prius
    Model:
    N/A
    I need help!!!

    I followed calcars guide on doing the EV mode. But, due to my inexperience, I tested hole #27 connection in the ECU plug. I think I pulled too hard and broke the wire leaving the connector that I inserted. Now I could not remove the connector and replace it with another one.

    Do you have any ideas on how to pull it out?

    Thanks for the guide and also if you have any ideas to help me.
     
    #1 CruZindon, Apr 30, 2011
  2. seilerts

    seilerts Battery Curmudgeon

    Joined:
    Mar 7, 2010
    3,326
    1,512
    38
    Location:
    Santa Fe, NM
    Vehicle:
    2005 Prius
    You need to lift up on the white terminal retainer and use some kind of tool, maybe an eyeglass screwdriver or a paperclip, to push the pin out. See page 8 in the calcars guide for pictures. Hope this helps, I know how tight it is down in there.

    I used an old piece of telephone wire (solid copper) and soldered it to the pin.
     
    #2 seilerts, May 1, 2011
  3. 2009Prius

    2009Prius A Wimpy DIYer

    Joined:
    Mar 25, 2009
    2,705
    510
    63
    Location:
    USA
    Vehicle:
    2009 Prius
    #3 2009Prius, May 2, 2011
  4. CruZindon

    CruZindon New Member

    Joined:
    Apr 3, 2011
    52
    1
    0
    Location:
    Irvine
    Vehicle:
    2008 Prius
    Model:
    N/A
    Got it out. Used a medium paper clip to push it out from bottom. Thanks for the assistance.
     
    #4 CruZindon, May 9, 2011
(You must log in or sign up to post here.)