1. Attachments are working again! Check out this thread for more details and to report any other bugs.

Prius traction battery replacement issues.

Discussion in 'Gen 2 Prius Care, Maintenance and Troubleshooting' started by nick linux, Apr 5, 2017.

  1. nick linux

    nick linux New Member

    Joined:
    Apr 4, 2017
    3
    0
    0
    Location:
    corvalllis or
    Vehicle:
    2005 Prius
    Model:
    N/A
    I am following a Youtube guide for replacing the hybrid battery and i have just taken off the cover to the terminals and have run into an issue. my tutorial says that after removing the electrical safety plug( orange thing on battery to pull off) that on both sets of terminals there should be zero volts where instead the ones connecting to the leads have no voltage but the others are putting out about 105 volts.is this normal and my tutorial is wrong or is there something more wrong with the battery. Inked20170404_210425_LI.jpg
     
    #1 nick linux, Apr 5, 2017
  2. ericbecky

    ericbecky Hybrid Battery Hero

    Joined:
    Mar 12, 2004
    4,365
    3,209
    1
    Location:
    Madison, Wisconsin
    Vehicle:
    2005 Prius
    Model:
    Two
    Make sure you have the orange HV safety plug removed and the 12v accessory battery unhooked.
     
    #2 ericbecky, Apr 5, 2017
  3. andrewclaus

    andrewclaus Active Member

    Joined:
    Sep 15, 2009
    993
    324
    0
    Location:
    Golden, CO
    Vehicle:
    2007 Prius
    Ditto the above. To reiterate, no that's not normal and do not proceed until there's no voltage at those terminals. Good thing you checked.
     
    #3 andrewclaus, Apr 5, 2017
  4. nick linux

    nick linux New Member

    Joined:
    Apr 4, 2017
    3
    0
    0
    Location:
    corvalllis or
    Vehicle:
    2005 Prius
    Model:
    N/A
    Yes i am sure that i have the 12v battery unplugged
     
    #4 nick linux, Apr 5, 2017
  5. goldfinger

    goldfinger Active Member

    Joined:
    Mar 12, 2012
    535
    402
    0
    Location:
    Buffalo
    Vehicle:
    2016 Prius
    Model:
    Three
    You're voltmeter has a very high impedance, at least 10 Mohm. The slightest leakage current will show voltage. You could get a banana jack and put a 1/2 w 470 kohm resistor across it to load down your meter. Or you could just not worry about it.
     
    #5 goldfinger, Apr 5, 2017
  6. nick linux

    nick linux New Member

    Joined:
    Apr 4, 2017
    3
    0
    0
    Location:
    corvalllis or
    Vehicle:
    2005 Prius
    Model:
    N/A
    How should i proceed in troubleshooting/diagnosing why this is happening.
     
    #6 nick linux, Apr 5, 2017
(You must log in or sign up to post here.)